Download Print this page
DCC Specialties RRampMeter Upgrade Manual

DCC Specialties RRampMeter Upgrade Manual

V1 to v2 or v3 upgrade

Advertisement

Quick Links

V1 to V2 Upgrade Kit Contents:
• Enclosure
• Face Plate
• Clip Leads
• Screws
• Pre-Cut Wires
V3 Upgrade Kit Also Contains:
• Switch
• 9 Volt Battery Clip
V1 to V2 or V3 Step 1:
Solder all four pre-cut wires to the terminals inside the enclosure.
RRampMeter
V1 to V2 or V3 Upgrade Guide
Page 1 of 5

Advertisement

loading
Need help?

Need help?

Do you have a question about the RRampMeter and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for DCC Specialties RRampMeter

  • Page 1 RRampMeter V1 to V2 or V3 Upgrade Guide V1 to V2 Upgrade Kit Contents: • Enclosure • Face Plate • Clip Leads • Screws • Pre-Cut Wires V3 Upgrade Kit Also Contains: • Switch • 9 Volt Battery Clip V1 to V2 or V3 Step 1: Solder all four pre-cut wires to the terminals inside the enclosure.
  • Page 2 V1 to V2 Step 2: Connect each wire to its respective terminal at J6, J7, J8, and J9 through the back of the board. Solder the wires from the front of the board and clip away any excess wire. V1 to V2 Step 3: Press the board into the enclosure and press fit the face plate on top.
  • Page 3 V1 to V2 Step 4: Screw all four screws into the holes in the back of the enclosure until they are hand tight. This completes the V1 to V2 upgrade. V1 to V3 Step 2: Locate S1 on the front of the board. Using a wick, remove the excess solder and the small bar that bridges the two terminals.
  • Page 4 V1 to V3 Step 4: Attach a 9 Volt battery to the battery clip and use the switch to turn the RRampMeter on to test it. If both the red and green lights turn on and voltage and current readings display, then it is good to go.
  • Page 5 V1 to V3 Step 5: Place the 9 Volt battery into the enclosure, tuck the wires in around it, and press the board onto the enclosure. Press fit the face plate into place and complete assembly by hand tightening the four screws into the back of the enclosure.