Advertisement
FREQUENCY CHARACTERISTICS (STANDARD WAVEFORMS)
Sine
10 μHz to 31 MHz
Square
10 μHz to 31 MHz
Triangle, Ramp
10 μHz to 500 kHz
Accuracy
0.0025 % (25 ppm)
Resolution
10 digits or 1μHz
ARBITRARY CHARACTERISTICS
Waveform length
2 points to 500,000 points
Vertical resolution
12 bits
Sampling rate
20ns to 50s
Accuracy
0.0025 % (25ppm)
Resolution
4 digits or 10 ps
OUTPUT CHARACTERISTICS ( into 50ohms)
Amplitude Range
10mV to 10Vp-p
Resolution
3 digits (1000 counts)
Amplitude Accuracy
± 1.25% ± 20mV (Amplitude: 1V to 10V)
± 2.5% ± 10mV (Amplitude: 10mV to 999mV)
Flatness(Sine)
0.1 dB at 10MHz
1 dB at 20 MHz
2 dB at 31 MHz
Offset Range
± 4.5V into 50 ohms, depending on the Amplitude setting
Offset Resolution
10 mV (Amplitude >= 1V)
1 mV (Amplitude < 1V)
Offset Accuracy
± 1.25% ± 20mV (Amplitude: 1V to 10V)
± 2.5% ± 2mV (Amplitude: 10mV to 999mV)
Output Impedance
50 ohm
Output Protection
The main output is protected against short circuit.
WAVEFORM CHARACTERISTICS
Harmonic Distortion
0 to 100 kHz: -55 dBc
100 kHz to 1 MHz: -45 dBc
1 MHz to 15 MHz: -35 dBc
15 MHz to 31 MHz: -25 dBc
Spurious
DC to 1MHz: <-65 dBc
1MHz to 31MHz ＜-50dBc
Square Rise/Fall
< 12 ns (10% to 90%) at full amplitude into 50 ohms
Variable Duty Cycle
Square :20% to 80% to 5 MHz, 40% to 60% up to 20MHz
Triangle: 10% to 90% to 500kHz
Symmetry at 50%
< 1 % ( < 5MHz)
OPERATING MODES
Continuous
Output continuous at programmed parameters.
Triggered
Output quiescent until triggered by an internal or external
trigger, then one waveform cycle is generated to programmed
parameters.
The trigger is a rising edge.
Up to 10MHz trig rate for ARB waveforms and 5 MHz in DDS
Gate
Same as triggered mode, except waveform is executed for the
duration of the gate signal. (The gate signal is high level.)
Burst
2 to 99,999 cycles
Phase
-360° to +360°, 0.1° resolution
Trigger Source
Trigger source may be internal, external or manual.
Internal trigger rate 0.01Hz-1MHz
[KENWOOD TMI HOME PAGE] http://www.kenwoodtmi.co.jp
●For safe and correct use, please read the instruction manual and cautions on safe before using the product.
●Please do not install and use the product at the place where is near water, under high humidity, a lot of steam, dust, lamp soot, etc.
(Those may cause fire, electric shock, breakdown, etc. )
●Specifications and design are subject to change without notice.●The color of this catalog may differ from the original due to limitation of photo and printing technique.
1850-1, Tsuruma Machida-shi, Tokyo, 194-0004 Japan
Phone: 81-42-788-4823 Fax: 81-42-788-4825
SPECIFICATIONS
MODULATION CHARACTERISTICS
Amplitude
Modulation
Frequency
Modulation
FSK
SWEEP CHARACTERISTICS
Sweep Shape
Sweep Time
Sweep trigger
VARIABLE PHASE
Range
Resolution
INPUTS AND OUTPUTS
Trigger In
Sync Out
Modulation IN
Reference IN-OUT
GENERAL
Store memory
Arbitrary memory
Dimensions
Weight
Interface
RS-232
GP-IB
Power Source
Line Voltage Range
Power Consumption
Fuse Rating
Atmospherics
Ambient
Tempera-
ture
Relative Humidity
Regulation(CE Labeled)
SAFETY
EMC
Accessories
Accessories
Internal:
0.01Hz-20KHz sine, square or triangle waveform
Variable modulation from 0% to 100%.
External:
5 Vp-p for 100% modulation, 10 kohms input imped-
ance.
Internal:
0.01Hz-20KHz sine wave, square or triangle
External:
5 Vp-p for 100% deviation, 10 kohms input impedance.
Internal rate
0.02Hz-1MHz
External
1MHz max
Linear and Logarithmic, up or down
100 ms to 500 s.
internal, external, continuous or burst
+360° to –360°
0.1°
TTL compatible.
Max. rate: 10MHz (Arb),
Minimum width: 50ns.
TTL pulse at programmed frequency, 50 ohms source
impedance.
5 Vp-p for 100% modulation.
10 kohms input impedance.
DC to >20 KHz minimum bandwidth.
Note: When FSK modulation, the external input
connector is "Trigger IN" connector.
10 MHz, TTL compatible, input or output, for external
unit synchronization.
50 full panel settings at power-off
500K points in flash memory
W: 213 mm x H: 88 mm x D: 300 mm
Aprox 3 kg
A DB 9-pin male DTE RS-232 interface
Fully programmable with IEEE488.2 compliance
100V to 240V／47Hz to 63Hz
40 VA max
T1A, 250V
Within
10ºC to 35ºC
Specifica-
Operating
0ºC to 50ºC
Storage
-10ºC to 60ºC
90 % RH, 10ºC to 30ºC
EN61010
EN55011、 EN55082
Instruction Manual (CD-R), AC cable
5MHz(DDS).
Advertisement
