Table of Contents
Advertisement
Quick Links
Model 59124
3-IN-1 Metal ,Live Wire And Stud Detector
1. ON/OFF Button.
2. Mode selector switch.
3. LCD display.
4. AC indicator.
POWER SUPPLY
The tools require one 9 volt battery
to operate.
BATTERY INSTALLATION
1. Open battery door on back of
case.
2. Connect a 9-volt battery to battery
clip.
3. Insert battery into case and
replace battery door.
Turning the power on/off
On : Press and hold the on/off button on
left side.
Off :Release on/off button.
Stud Scan or Deep Scan modes
Stud Scan mode for depths to about 3/4
in. (18mm).
Deep Scan mode for Depths to about
11/2 in(30mm).
Position the Scanner Flat against the
Wall. Select mode. Press and hold on/off
button.
Sounds off the auto finish.
Slowly slide unit horizontally across
wall, right of left.
When full bars appears on the LCD and
steady tone sounds, you have located the
edge of the stud. Mark this spot.
Continue holding on/off button in and
scan beyond the marked spot until bars
disappears.
Advertisement
Table of Contents
Summary of Contents for Morris 59124
- Page 1 Model 59124 Turning the power on/off 3-IN-1 Metal ,Live Wire And Stud Detector On : Press and hold the on/off button on left side. 1. ON/OFF Button. Off :Release on/off button. 2. Mode selector switch. 3. LCD display. Stud Scan or Deep Scan modes 4.
- Page 2 Without releasing on/off button, slide Continue scanning beyond the marked scanner in reverse direction to locate the spot to detect width of target. If target is other edge of stud. Mark this second wide, reverse to locate and mark the spot.
Need help?
Do you have a question about the 59124 and is the answer not in the manual?
Questions and answers