Advertisement
Quick Links
Advertisement
Summary of Contents for OCENAV ATM105B
- Page 1 AUTOPILOT WIRELESS REMOTE CONTROL User manual www.ocenav.com...
- Page 2 The information in this document is subject to change without notice. Ocenav reserves the right to change or improve its products and to make changes in the content without obligation to notify any person or organization about these changes or improvements.
- Page 3 REMOTE UNIT – ATM105B Operation: The ATM105B remote unit operates with Raymarine STxxxx and SmartPilot pilots in combination with the ATM105A2 gateway, with Raymarine Evolution and Simrad / B&G pilots: APxx / ACxx / NAC2 / NAC3 in combination with the ATM105A3, and directly with the Ocenav STE300 pilot.
- Page 4 VANE - Active pilot, the course maintains the wind angle. TRACK - Active pilot, the course follows the Navigation route. NoDRF - Active Pilot, NO DRIFT Heading (Constant COG). (Only operational on Simrad, B&G and Ocenav pilots): (4) - Alarm display area, alternate screen: a) Standard alarms: “BAT LOW”...
- Page 5 b) Alarms added by the complement: DEPHT – Minimum Depth alarm. "WIND >>" - True wind intensity exceeded. "RADAR" - AIS and ARPA (Radar) target proximity alarm. "ANCHOR" – Anchor drag alarm. NOTE: The alarms kit includes a buzzer with led that connects to the control panel, and which is activated in the presence of any alarm.
- Page 6 Keyboard functions: PAGE - This key has two functions, device on/off and display page change. It is possible to send a direct order to the pilot without activating the screen. To do this, press directly on the key or keys, without previously pressing Page.
- Page 7 (-1 and +1) - This key combination activates the navigation in NO DRIFT mode, keeping the COG. The GPS needs to supply valid data. (Only for Simrad / B&G and Ocenav STE300 pilots). (STBY) – This key has 2 functions. A normal pulse disables the pilot AUTO mode.
- Page 8 Data Pages: 1 - Wind and rudder angle Information. The data shown correspond to the apparent wind direction and speed. The numerical value within the circumference is the angle in degrees and their speed in knots. the needle indicates the direction and surrounding points are located at distances of 30 degrees.
- Page 9 3- Waypoint distance and UTC / LOCAL time: WPT DIST – Distance on the Great circle line to the waypoint. Value in nautical miles. TIME UTC – Coordinated universal time. No local corrections. LOCAL TIME – Is the time UTC +/- the local correction . The correction is settable within the remote configuration pages.
- Page 10 Configuration pages: In the configuration pages, the -10 and +10 keys are used to change the active line (up and down), and -1 and +1 keys to change the parameter value. Configurable parameters: Power Off – Time for auto power off. Value of 1 to 10 minutes. Disp Contrast –...
-
Page 11: Warranty
In its sole discretion, Ocenav will repair or replace any defective product or component returned during the Warranty Period under the terms, conditions and limitations set forth herein. - Page 12 Other conditions: To the competent authority, this warranty is the only guarantee that Ocenav offers and is applicable only to new products purchased in Spain. The provisions of this warranty pleased any other written warranties, express or implied, written or oral, including any commercial or suitable security for a particular purpose.