Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Patriot PT-SM36
-
Page 2: Important For Your Safety
IMPORTANT FOR YOUR SAFETY THIS MANUAL HAS BEEN PREPARED FOR PERSONNEL QUALIFIED TO INSTALL GAS EQUIPMENT, WHO SHOULD PERFORM THE INITIAL FIELD START-UP AND ADJUSTMENTS OF THE EQUIPMENT COVERED BY THIS MANUAL. POST IN A PROMINENT LOCATION THE INSTRUCTIONS TO BE FOLLOWED IN THE EVENT THE SMELL OF GAS IS DETECTED. -
Page 3: Installation
SALAMANDER GENERAL Patriot Equipment are produced with quality workmanship and materials. Proper installation, usage, and maintenance of your Salamander will result in many years of satisfactory performance. It is suggested that you thoroughly read this entire manual and carefully follow al l of the instructions provided. -
Page 4: Installation Codes And Standards
The installation location must allow adequate clearances for servicing and proper operation. A minimum front clearance of 24" is required. Do not obstruct the flow of combustion and ventilation air. Adequate clearance for air openings into the combustion chamber must be provided. Make sure there is an adequate supply of air in the room to replace air taken out by the ventilating system. - Page 5 The gas supply line must be ¾” or larger. If flexible or semi-rigid connections are used, the inside diameter must be the equivalent of ¾” iron pip e or larger. All connections of the flexible and semi-rigid type must comply with all local and national requirements.
- Page 6 If the Salamander is to be mounted over a gas range WHICH IS DESIGNED SPECIFICALLY TO RECEIVE THIS PATRIOT SALAMANDER, it must be installed according to the instructions below: Using the twelve bolts provided (balloon 1), install mounting brackets (balloon 2) on both top mounting posts (balloon 3).
- Page 7 Salamander - Range back installation 1. Take off the 12 self-tapping screws on the range back. 2. Insert the Salamander support column into the Range back plate as shown and tighten it with screws...
- Page 8 3. Lift Salamander and attach it to the proper position of the support column...
- Page 9 4. Take two brackets out of the package...
- Page 10 5. Attach Salamander mounting track to the appropriate screw according to the hole position and tighten all screws...
-
Page 12: Operation
OPERATION WARNING: THE SALAMANDER AND ITS PARTS ARE HOT. BE CAREFUL WHEN OPERATING, CLEANING OR SERVICING THE SALAMANDER. CONTROLS Angled Handle —Elevates or lowers the broiling drawer and grate to different positions. Grasp the handle and pull towards Salamander cavity. This releases the mechanism and allows the lifting handle to move into the desired position. Burner Valve —... - Page 14 4. Turn pilot adjustment screw clockwise, then light standing pilot and adjust flame to be 1/4" high. A product with the Patriot name incorporates the best in durability and low maintenance. We all recognize, however, that replacement parts and occasional professional service may be necessary to extend the useful life of this unit.
- Page 15 Patriot warrants its equipment against defects in materials and workmanship, subject to the following conditions: Patriot gas equipment is warranted for one (1) years, effective from the date of purchase by the original owner. A copy of the original receipt or other proof of purchase is required to obtain warranty coverage. This warranty applies to the original owner only, and is not assignable.