Owon SAC451 Quick Start Manual
  1. Manuals
  2. Brands
  3. Owon Manuals
  4. IP Access Controllers
  5. SAC451
  6. Quick start manual
Owon SAC451 Quick Start Manual

Owon SAC451 Quick Start Manual

Smart access control
Hide thumbs
1
2
3
4
5
6
7
8
9

Advertisement

Table of Contents

SAC451 Smart Access Control
Quick Start Guide

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SAC451 and is the answer not in the manual?

Questions and answers

Summary of Contents for Owon SAC451

  • Page 1 SAC451 Smart Access Control Quick Start Guide...
  • Page 2 Welcome The Smart Access Control SAC451 is used to control the electrical doors in your home. You can simply insert the Smart Access Control into the existing and use the cable to integrate it with your existing switch. This easy-to-install smart device allows you to control your lights remotely.

  • Page 3: Get To Know Your Device

    Get to know your device Reset button LED indicator Reset Button • Bind mode. Press and hold the Reset button for about three seconds until the LED indicator flashes three times to enter bind mode. • Reset. Press and hold the Reset button for ten seconds until the LED indicator flashes three times to reset the Smart Access Control to default factory setting, the LED indicator will keep flashing after the device is successfully reset.
  • Page 4 LED indicator The LED status gives the following information of the Smart Access Control: LED status What it means LED keep flashing Device has not joined a network. (0.5s On, 2s Off) Flashing three times Intuitive End Device Bind or Return (0.1s On/Off) to Factory Settings.

  • Page 5: Get Started

    Get started 3.1 To get started, you will need: A ZigBee gateway. A pin. 3.2 Installation Please refer to the installation diagram below to install the Smart Access Control.
  • Page 6 Note: output is pulse singal, width 2s. 6-24V DC IN Connection box Installation diagram...
  • Page 7 3.3 Connect to the gateway's network 1. Install the Smart Access Control and the LED indicator will start flashing (reset the Smart Access Control if not). 2. Set your ZigBee gateway to permit joining and the Smart Access Control will join the gateway's network automatically, the LED indicator will become steady when successfully joined.

  • Page 8: Technical Specifications

    Technical Specifications Wireless Connectivity • ZigBee 2.4GHz IEEE • Operating frequency: 2.4GHz RF Characteristics • Internal PCB Antenna • Range outdoor/indoor: 100m/30m ZigBee Profile • Home Automation Profile Operating Voltage • DC 6-24V Operating Current • 30mA @ 12V Max Current •...

  • Page 9: Safety Handling

    Safety Handling WARNING: Failure to follow these safety notices could result in fire, electric shock, other injuries, or damage to the Smart Access Control and other property. Read all the safety notices below before using the Smart Access Control. • Avoid high humidity or extreme temperatures. •...

Table of Contents