Advertisement
bag at back of cabinet. Place the
spacers onto screws and then put
the screws in the hole where the
nit is not level, the doors and magnetic seal
handle is to be installed. Please make
sure the spacer is correctly in place
.
before you put the screws in the hole.
3. Align the handle with screws,
tighten the screws using a screw
driver until the handle is both flush
ance to be installed under bench and ensures
and secured tightly against the
se to raise the height up to 880mm or clockwise
door side. (DO NOT over-tighten as
this may cause damage to the door
surface)
ust
4. After handle fixed well, put the door
seal back to the door to cover the
hole.
IN STA LL ATI ON
The appliance is designed to be built-in,
recessed or free standing installation.
The minimum space required is:
830H x 615W x 605D (mm)
615
anding
)
nstallation
For a complete guide, refer to user manual,
page 9–11.
D E TAI L S
Size (mm):
820—880H x 595W x 575D
M O D E L
/
Door seal
Congratulations on your new InAlto
Single Zone Beverage Centre!
I B C 1 7 8 . 1
Defrosting
The wine cooler is designed to defrost automatically every 4 hours. The
During defrost, the compressor stops working and fan keeps on running
Q U I C K S T A R T G U I D E
Door alarm
The wine cooler is equipped with an alarm that will sound if the door is o
or press any key once to switch off the alarm.
Controls
It is recommended that you install appliance in a place where the ambie
ambient temperature is above or below recommended temperature, the
example, placing your unit in extremely cold or hot conditions may caus
operation temperature range may not be reached.
1
TH E CON TRO L S
Your Beverage Centre Controls
To switch the power on/off
Press and hold the power button for 6 seconds to switch the wine coo
1
Power Button
Press and hold the power button for 6 seconds again to switch the win
Press and hold the power button for 6
seconds to switch the beverage centre on
To change the temperature
and off.
Continue to press the "+" or "-" buttons until the required temperature i
2
Light Button
The preset temperature is 12 C/54 F.
To change the temperature display from Fahrenheit to Celsius, or Celsi
Press to turn the internal light on and off.
same time for 2 seconds. Tips, please see the "
3
"+" Button
The display shows the current internal temperature when the wine coo
Press to increase the set temperature shown
on the display.
Optimal temperature selection
3
Whilst wine is best stored at temperatures between 13 and 15 C , your w
4
"-" Button
As a guide for red wine this is between 15 and 17 C, and for white wine
Press to decrease the set temperature
shown on the display.
To use the internal light
Press the light button to switch the light on or off.
For a complete guide, refer to user manual,
To turn the light ON when door opens, press the light button for 6 sec
page 11.
door controls function is ON
To turn the light function OFF, press the light button for 6 seconds, the
control function is OFF.
To lock the whole panel
Press power button and light button at the same time for one second,
Press power button and light button once again, all the buttons will be
Tips, please see the "
SUPP O RT
Telephone: 1300 11 4357
Email: support@residentiagroup.com.au
2
3
12
o
o
" symbol on control panel.
W W W . I N A L T O . H O U S E
4
Key:
1 - Power button
2 - Light button
3 - "+" button
4 - "-" button
" symbol on contro
o
o
Advertisement
