Bancroft MAD SHARK V2 RTR MINI EP F1 SPEED BOAT Instruction Manual

MAD SHARK V2 RTR MINI EP F1 SPEED BOAT
1) MAD SHARK V2 RTR MINI EP F1 SPEED BOAT
2) Transmitter
3) 7.4V Power Pack
4) 2S/3S balance charger with AC power cable
3
Caution for Li-Ion battery:
ESC with low voltage hard cut off at 3.2V per cell, when driving your boat , as soon as you notice boat stop, that
means ESC low voltage cut off effective, you should immediately drive boat back to shore in slow speed ,
recharge battery and race again. don't keep racing boat when ESC low voltage cut off effective, otherwise, you will
allow battery over discharge, battery voltage will reach very low and won't be recharged again.
Caution:
1. Continuous running of the model will generate high heat levels, Which will lead to premature wear of the motor.
Once your power pack is exhausted, we recommend that you open model's upper deck and let motor air cool for
around 15 minutes before installing a fresh power pack. This action will protect motor and extend its working life.
2. Before racing your model boat, carefully check silicone tube for guarantee good water cooling system; Avoid
water inlet on the bottom of hull become deformed, otherwise, water cooling system failure, this may lead to
ESC burned out and motor defected.
IMPORTANT
The Mad Shark is designed for use in fresh water only. It is not designed for use in salt water!
The Mad Shark is not intended for persons under 14 years of age, unless closely supervised by an adult.
SKU #BNC1031-001
4 5
Mad Shark V2 RTR MiNi EP F1 Speed Boat
5) Boat Stand
6) 9V Dry battery (for Transmitter)
7) 2.5mm Allen Key(For pushrod tighten)
2.0mm Allen Key (for Grub Screws)
6 7