Speakman T-5000 Installation Instructions

INSTALLATION INSTRUCTIONS
T-5000
Two-Piece Toilet
92-T-5000-05
NEED HELP?
For additional assistance or service please contact:

VERIFY ROUGH-IN

1
For your Toilet to fit correctly, the rough-in distance between the finished wall to the center of the
Closet Flange must be at least 12"
Finished
Water
Supply
Valve
12"

INSTALL SUPPLY LINE TO TANK

Install Water Supply Line to the Inlet Shank
3
of the Fill Valve. Tighten into position. Do
Not Over-Tighten connection or damage
may occur.
DRY CONNECTION ONLY!
DO NOT USE ANY THREAD SEALANT ON THIS CONNECTION
TOOLS & SUPPLIES NEEDED
Phillips
Flat Tip
Screwdriver
Screwdriver
Slip Joint Level
Wrench
Measuring
Tape
www.speakman.com
800-537-2107
Wall

INSTALL TANK BOLTS

Install the Conical Rubber Washers onto
4
Tank Bolts with the tapered side facing
down. Reach inside the Tank and position
the Tank Bolts through the Bolt Holes in
the bottom of the Tank. From below the
Tank, install a set of Rubber Washers,
Metal Washers, Lock Washers, and Nuts.
Wrench tighten.
CAUTION: Do not over-tighten or damage may occur.
IMPORTANT
Adjustable
SAFETY TIPS:
Wrench
Be sure to read and understand all instructions
before beginning installation.
Inspect all connections after installation.
Be sure to wear proper eye protection.
MAINTENANCE:
Your new Speakman Product is designed for
Supply Hose with
years of trouble-free performance. Keep it
7/8" Ballcock End
looking new by cleaning it periodically with a
(Included)
soft cloth. Avoid abrasive cleaners, steel wool,
and harsh chemicals as these will dull the finish
and void your warranty.
Your new Speakman Toilet includes a premium
fill valve with an internal filter designed to trap
impurities allowing for reliable operation of the
fill valve. Periodic removal and cleaning of the
filter is recommended for optimal performance.
Please see the "Fill Valve Filter Cleaning"
section of this document for more information.
NOTE:
This installation manual covers several
models of Toilets. While the appearance of your
Toilet may differ from those shown, the
installation method is the same.
2
Place the Toilet Tank upside down onto padding. Inspect the pre-installed Fill Valve Nut and Flush
Valve Nut for a secure connection.
Fill Valve Nut: Hand tighten only!
Flush Valve Nut: Hand tighten, then wrench tighten 1/2 turn.
Place the Tank-to-Bowl Gasket onto the Flush Valve Nut. While pressing down, spread the
Gasket over the Nut until the Gasket touches the bottom of the Tank.
Note: A small gap between the Tank Bottom and Gasket is allowable.
Fill Valve Nut
Closet
Flange
Position Tank above Bowl and guide Tank Bolt Assemblies and Supply Line through the
5
appropriate holes in the Bowl. From below, install a 2
Nuts to secure the Tank to the Bowl. Wrench tighten until Tank makes several points of contact to
the bowl.
DO NOT OVER-TIGHTEN
Connections OR DAMAGE MAY
OCCUR.
DO NOT USE CHLORINE OR ANY
CHEMICALLY RELATED
COMPONENTS AS THIS WILL
RESULT IN DAMAGE TO TANK
COMPONENTS AND MAY CAUSE
FLOODING AND PROPERTY
DAMAGE.
USE OF CHLORINE OR
CHEMICALLY RELATED
COMPONENTS WILL VOID
WARRANTY.

PREPARING THE TANK

Flush Valve Nut

SECURING THE TANK TO THE BOWL

nd set of Metal Washers, Lock Washers, and
CAUTION: Do not over-tighten or damage may occur.
WARNING
Tank-to-Bowl
Gasket