Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Morgan MRV-VAC 1
Summary of Contents for Morgan MRV-VAC 1
- Page 1 Robot Vacuum Cleaner MRV-VAC 1...
- Page 2 C O N T E N T S Parts Identification Specifications Safety Precautions 3 - 4 5 - 7 Operating Instructions Care & Cleaning Care & Cleaning 5 - 7 Trouble Shooting - 10...
-
Page 3: Parts Identification
PARTS IDENTIFICATION Accessories... -
Page 4: Specifications
SPECIFICATIONS Rated Input: 100-240V~, 50/60Hz 0.5A Max (for switching adapter) Rated Output: 19VDC, 600mA (for robot vacuum cleaner) Battery: 13V 1500mAh Maximum working time: 85-95 minutes Charging Time: 4 hours SAFETY PRECAUTIONS When using the appliance, especially when children are present, basic safety precautions should always be followed including the following: 1. - Page 5 SAFETY PRECAUTIONS 9. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliances by a person responsible for their safety.
- Page 6 Thanks for purchasing the MRV-VAC 1 Robot Vacuum Cleaner! This revolutionary Robot Vacuum Cleaner is equipped with functions suitable for cleaning up floor surfaces of home and office, such as wood, tile, and linoleum. The MRV-VAC 1 Robot Vacuum Cleaner is definitely a good household helper. Battery Installation Before installing or removing the battery, the product must be disconnected from the power source.
- Page 7 OPERATING INSTRUCTIONS Battery Removal Open the battery cover，disconnect the end of the battery to the interface. Recommended to remove the battery if won’t be using for an extended period. Recharging Battery Before charging, make sure the battery is correctly installed. The procedure of charging the product is as follows: firstly, connect the adapter output into the DC jack, and then plug into power socket of the other end, then blue light will flash.
- Page 8 OPERATING INSTRUCTIONS Side Brush installation 1. Install the L side brush at L place and R side brush at R place on the bottom and push to fix it. 2. To pull up the side brush for remove it from the unit. Cleaning pad installation 1.
-
Page 9: Care And Cleaning
CARE AND CLEANING Cleaning Dust Bin Open the upper cover by lifting the lid near the power on/off button. Place your finger into the dust bin groove and grip to take it out. Open the lid of dust bin. Take out the inner filter Empty the dirt in the dust bin. - Page 10 CARE AND CLEANING Rinse the dust bin with tap water. Do not wash it in washing machine, dish-washing machine or other machine. Periodically clean the filter with a soft bristle brush. Reinstall the filter and the dust bin lid once they get dried. Put back the dust bin into the cleaner.
- Page 11 CARE AND CLEANING Cleaning intake After repeated use for some time, dirt and dust might accumulate around the intake of the product, to ensure its best cleaning efficiency and constant airflow it should be cleaned periodically. Remove the external power source. Clean up the dirt and dust at the intake.
-
Page 12: Troubleshooting
TROUBLE SHOOTING Problem Possible Cause Solution Red LED stays after 1. Battery Low condition 1. Recharge the battery power on 2. Main body is picked up 2. Re-place the robot on the floor Vacuum on but can 1. The dust bin is full 1.
Need help?
Do you have a question about the MRV-VAC 1 and is the answer not in the manual?
Questions and answers