Page 1
Pivot Doors with or without S i d e P a n e l...
Page 2
IMPORTANT Please read carefully the following instructions before installing your shower enclosure to ensure safe and proper use and avoid any injury to either the installer or user. Before installing please read also the Manual Instruction. Failure to comply may invalidate your guarantee. Pivot Door Components list Fixings Pack Description...
Page 3
Prior to installation: Before Installing the shower screen, install the shower tray as per the manufacturers instructions making sure that tray is level in all directions. step 1. Installation in an alcove. Position the wall profiles approx 8mm in from the edge of the tray or inside of up-stand.
Page 4
step 5. Screw one wall profile to the wall making sure you keep the profile vertical. Use the 30mm screws provided. Repeat the above procedures for the Second profile, in case of installing with side panel. Make sure the distance from the edge of the tray is the same as the previous profile.
Page 5
step 10. Fit the profile cover caps as shown. Then apply the badge as indicated. step 11. Adjust the door by slackening the hing block screws top and bottom. The glass door should be square in the frame and operate smoothly. If the door fails to shut positively make sure the polarity of the magnets are correct.
Page 6
step 15. Drill through the pre-drilled holes in the shower profile into the side panel profile with the 3.2 mm drill bit provided. Secure with the 10 mm screws provided. Then, install the screw cover strip and the profile cover caps provided.
CARE INSTRUCTIONS Shower enclosures should be cleaned after every use. To prevent limescale from building up, use a squeegee, a soft cloth or chamois leather - but no cleaning agent - to wipe off any water droplets left after showering. Residue left by bodycare products (liquid soap, shampoo, shower gel) can also cause substances to accumulate.
Need help?
Do you have a question about the GEO-6 and is the answer not in the manual?
Questions and answers