Download Print this page
Hartell A3X Installation & Operation

Hartell A3X Installation & Operation

Commercial condensate removal pumps

Advertisement

Quick Links

201 Ivyland Road
I N S T A L L A T I O N & O P E R A T I O N
Introduction
The Hartell A3 & A5 series condensate removal pumps are designed to collect and automatically remove the water pro-
duced by air conditioner evaporator coils and/or steam humidifier units (for use with water up to 212°F). As designed, the
pump will collect water in its integral reservoir. After enough water has been collected, an internal float switch activates
the pump and water "pump-out" will begin. Once enough water has been evacuated from the reservoir, the pump will
automatically de-activate and wait to begin the cycle again.
As with all Hartell products, the A3 and A5 series of pumps have been carefully engineered to provide long-term, trouble-
free service. Thorough factory testing of each pump ensures your pump has been built with the highest quality workman-
ship and materials.
WARNING! WARNING! WARNING!
WARNING! To reduce the risk of electrical shock this pump must be grounded with a properly wired grounding con-
nection.
WARNING! Disconnect electrical power at the power source (fuse box, circuit breaker, etc.) before servicing pump!
WARNING! DO NOT handle the pump with wet hands; or, while standing on a wet/damp surface or in water.
CAUTION! CAUTION! CAUTION!
CAUTION! Pump should only be used to pump liquids compatible with pump component materials. DO NOT use to
pump flammable or explosive fluids. DO NOT use in explosive atmospheres.
CAUTION! In any installation where property damage and/or injury could occur as a result of an inoperable or leaking
pump, a back up system such as high level safety float switch and/or alarm is highly recommended.
CAUTION! For correct wiring installation, refer to the enclosed wiring diagram.
CAUTION! THE A5X PUMP SERIES MUST BE SUPPLIED BY A DEDICATED 20 AMP SERVICE AND BREAKER
TO HANDLE CURRENT DRAW DURING MOTOR START-UP.
CAUTION! Make certain that line voltage corresponds to voltage specified on pump motor's nameplate.
CAUTION! ALL WIRING MUST CONFORM TO LOCAL ELECTRICAL CODES. In areas where local codes are non-
existent, the National Electrical Code applies.
HARTELL A3/A5 series condensate pumps are guaranteed to be free from defects in workmanship or materials and to
function satisfactorily, when properly installed, for a period of ONE (1) year from date of installation. See our website for
additional warranty information at www.hartell.com
This guarantee does not apply if the product has been misapplied or mechanically damaged, HARTELL assumes no liabil-
ity for resultant damages of any kind arising out of the use of its products.
Ivyland, PA
18974
A3X / A5X
Commercial Condensate Removal Pumps
READ ALL INSTRUCTIONS BEFORE INSTALLING PUMP!
FAILURE TO FOLLOW WARNINGS & CAUTIONS COULD
RESULT IN BODILY HARM AND/OR PROPERTY DAMAGE!
ONE YEAR LIMITED WARRANTY
Phone: 215-322-0730
Fax: 800-322-5519
Web: www.hartell.com
Email: info@hartell.com

Advertisement

loading

Summary of Contents for Hartell A3X

  • Page 1 As with all Hartell products, the A3 and A5 series of pumps have been carefully engineered to provide long-term, trouble- free service. Thorough factory testing of each pump ensures your pump has been built with the highest quality workman- ship and materials.
  • Page 2 Reconnect the drain line tubing to the pump inlet. Operation When properly installed, the operation of the HARTELL pump is automatic. Under most circumstances, the pump requires little maintenance for efficient operation. If a problem occurs, check the following items or consult with the firm where the pump was purchased.

This manual is also suitable for:

A5xA5x-115