Download Print this page
Pottery Barn Trigger Lift Cantilever umbrella Instruction Manual

Pottery Barn Trigger Lift Cantilever umbrella Instruction Manual

Advertisement

Quick Links

WARNING: Do not leave your
umbrella
base designed for it.
Step 1
Secure your cantilever umbrella to the base,
See separate base instructions.
Note: For safety reasons 2 persons
are required to co-lift the umbrella to
the base.
Step 2
Spueeze the Trigger and push up to
the first or second position.
Crank the handle clockwise to open
your umbrella.
WARNING
Do not crank in counter clockwise
direction as the umbrella will go up
but not hold and suddenly will come
down.
Step 3
Once your umbrella has been opened
you can now squeeze the trigger and
push up to the highest position . The
fully open position will have the canopy
parallel to the ground.
Trigger Lift Cantilever umbrella
Instruction Manual
in the open position during wind or rain storms. Close your umbrella when not in use. This umbrella must be used with the
Patented product

Advertisement

loading
Need help?

Need help?

Do you have a question about the Trigger Lift Cantilever umbrella and is the answer not in the manual?

Questions and answers

Summary of Contents for Pottery Barn Trigger Lift Cantilever umbrella

  • Page 1 Trigger Lift Cantilever umbrella Instruction Manual Patented product WARNING: Do not leave your umbrella in the open position during wind or rain storms. Close your umbrella when not in use. This umbrella must be used with the base designed for it.
  • Page 2 . a solution of mild soap and wa rm water. · Do not cover with plastic or similar materials that will trap moisture. Pottery Barn umbrell a covers are vented and can be used. Thank you for your purchase...
  • Page 3 Assembly instructions Tiles not included Patented product Parts Required: Cover ring (1x) Steel plates D (1x) Steel plates E (1x) Rotation mechanism (1x) Cover (1x) Tile (4x) Stem (1x) Tightening knob (1x) (Separate pack) Tools Required: Hardware Enclosed: Wrench (5mm) (1x) Wrench (6mm) (1x) Bolt (M8x30mm) (4x) Bolt (M8x13mm) (4x)
  • Page 4     Canopy For Umbrella   Parts Included: (1) Umbrella Canopy 1. Place umbrella frame on flat 2. One hand holds rib, while one hand pulling pocket, to set each Rib work area.Unscrew Finial End into each pocket.(Fig 2-1/2-2) from top of umbrella frame.Place Canopy over NOTE: (For Rectangular canopies only) umbrella frame.