Tiger MBI-A Instructions

Stainless Steel Bottle
Instructions
Thank you for purchasing a "TIGER" Stainless Steel Bottle.
Please read the instructions completely before use.
Keep these instructions for future reference.

How to attach the belt

Open button
Convex
Bracket
Body

Safety Precautions

Safety Precautions
MODEL
MBI-A
Important!
Keep out of reach of children.
Use a cup to drink when the
product contains a hot beverage.
Be sure to close the stopper
securely then press the close
button. And then check that the
contents will not leak when the
product is tilted.
Do not put dry ice or carbonated
beverages in the product.
Do not store milk, dairy products, or
certain fruit juices in the product.
Do not place the product near
stoves, open flames, or other
Cup
sources of extreme heat.
Do not heat the product in a
Close button
microwave oven.
Inner stopper A
Do not fill the product above the
maximum level shown below.
Inner stopper B
Large gasket
Maximum level
Small gasket
Beverage
Do not press the open button when
the product tilted or near face.
Consume the beverage within the
day. Otherwise, it goes bad or
spoils.
Noncompliance to this instruction
may result in scald or injury.
Belt
Do not swing the product while
holding the belt.
Do not touch the brim with hot
tea kettle spout.
Do not use the product for any
purposes other than drinking and
keeping beverages warm or cold.
Do not knock over, drop or expose
the product to excessive shocks.
Do not disassemble or attempt to
repair the product by yourself.
Be sure to clean the product
immediately, especially for sports
drinks.
Do not store soups or beverages
containing salt in the product.
Do not neglect the product in the
bag.
Do not use chlorine-based
bleaches or cleaner when cleaning
the product.
Keep the product upright position
all the time.
Do not add tea leaves and fruits
juice with pulp.
Approx. 1cm
1/2-inch
1

How to Use

How to Use
1
To keep your beverage warm or cool longer.
Pour hot (or cold) water into the product, and let it sit for one or
two minutes to allow the inside of the product to heat (or cool).
2
Remove the cup, press the open button, tilt the product, and
then pour the beverage.
Open button
3
After pouring the beverage, stand the product upright, wait for 2
to 3 seconds, and then press the close button.
Open button
Close button
Spout
Liquid remains
in the inner
stopper.
Do not push close button when it tilted. Liquid remains in the inner stopper and it
may leak.
The product rattles when shaken.
This is caused by a metal sheet moving inside the product and it doesn't affect
the performance of the product. The metal sheet is used for boosting the
performance of heat retention.
2