Table of Contents
Advertisement
Quick Links
Q80A Swing Gates Control Panel
QUICK START GUIDE
PRE-PROGRAMMING CHECKLIST
Before programming the Q80A Control Panel, ensure the gate leafs, hinges and
mechanicals stops are in good order –and the leafs can operate free of obstruction.
The gate has mechanical
The gate hinges are in
The gate leafs swing
stops in both the open and
good condition and are
freely and are clear
closed positions.
suitably lubricated.
of obstruction
IMPORTANT: If programming a single-leaf swing gate – the following setting must be enabled
1 / 6
Advertisement
Table of Contents
Summary of Contents for Gate Motors Q80A
- Page 1 Q80A Swing Gates Control Panel QUICK START GUIDE PRE-PROGRAMMING CHECKLIST Before programming the Q80A Control Panel, ensure the gate leafs, hinges and mechanicals stops are in good order –and the leafs can operate free of obstruction. The gate has mechanical...
- Page 2 Q80A Swing Gates Control Panel QUICK START GUIDE 1 Power Up the board 2 Using the programme settings, navigate to PP (see page 28) – Set P1/2/3 to 0 (zero) to disable all stop functions 3 Partially open the gates using the manual release key –...
- Page 3 Q80A Swing Gates Control Panel QUICK START GUIDE 5 You can now programme radio remotes through the AA settings (see page 12) 3 / 6...
- Page 4 Q80A Swing Gates Control Panel QUICK START GUIDE 4 / 6...
- Page 5 Q80A Swing Gates Control Panel QUICK START GUIDE 6 You should now enable the photocells – P2 for Closing (primary) P3 for Opening (additional set inside the property) 7 The motors are now ready for fine tuning (Torque Settings, page 17 & Obstacle Detection,...
- Page 6 Q80A Swing Gates Control Panel QUICK START GUIDE www.gatemotors.co.uk/help-and-support 6 / 6...
Need help?
Do you have a question about the Q80A and is the answer not in the manual?
Questions and answers