Page 1
RADIO CHANNEL PACK VEGA RK-2.4 User manual The Vega RK-2.4 pack consists of two RF tags, a wireless locking relay, and a reader that can communicate with tags and relays over the air. The reader can be used both with tags without relays and with relays without tags, depending on the specific task.
Page 2
VEGA RK-2.4/User manual Document information Title Vega RK-2.4 pack Document type Manual Document code В-01RK2.4-01 Number and data of last revision 01 of 21.08.2017 This document is applicable for following devices: Line Device Reader RF tag Wireless locking relay Revision history:...
VEGA RK-2.4/User manual INTRODUCTION This manual applies to a pack of interacting devices (hereinafter - VEGA RK-2.4), consisting of two radio tags, a wireless locking relay, and a reader that works with tags and relays via radio channel produced by Vega-Absolute LLC and defines the order of installation and connection, and contains a description of the settings and functionality.
VEGA RK-2.4/User manual 1 DESCRIPTION AND PRINCIPLE OF OPERATION The Vega RK-2.4 pack consists of two RF tags, a wireless locking relay, and a reader that can communicate with tags and relays over the air. The pack is intended for use in conjunction with a monitoring device that controls the locking relay, using the reader as an intermediary.
VEGA RK-2.4/User manual 3 GET STARTED CONNECTION DIAGRAM The figure below shows the connection diagram. The exchange of the reader with tags and relays is carried out over the radio channel. The reader is connected to the monitoring device via 4 wires: the VCC output of the reader is connected to the battery, the other three outputs of the reader are connected to the monitoring device.
VEGA RK-2.4/User manual Contact Color Description Relay Brown Power contact Brown Power contact Power 12 V Black Ground - Reader Black Ground - Yellow Relay control input, control voltage 12 V Blue Output of presence of the tag, open-collector type...
VEGA RK-2.4/User manual 4 OPERATION DESCRIPTION OF THE READER WITH LOCKING RELAY Each time the signal at the reader control input (lock / unlock) changes, a wireless command is sent to lock / unlock the relay. If the relay is not in sight or the relay is not energized, then the command from the reader is repeated for 15 seconds.
Page 10
VEGA RK-2.4/User manual try to communicate with the reader for 15 seconds, if the reader does not respond, it will automatically set the blocking status and start motion control. Rev. № 01 of 21.08.2017...
VEGA RK-2.4/User manual 5 RELAY AND TAGS REGISTRATION ALERT SIGNALS OF THE READER The following information signals are used for data transmission. In programming mode: 1 impulse – 1 tag is registered in the reader 2 impulses – 2 tags are registered in the reader 3 impulses –...
VEGA RK-2.4/User manual overwritten, and the fourth tag will be entered into the first memory cell. An attempt to re-register a mark already registered in the current session will not lead to deletion of other marks, the tag will be overwritten in the cell where it was already registered.
VEGA RK-2.4/User manual «NULLING» OF THE RELAY To reset an already registered relay, it is necessary to reverse its polarity. Reverse polarity of the power supply means + 12V to the black wire and ground to the red wire. The relay will start, reset its registration, and click the key 3 times. Nulled relay can be registered again, if the relay is not nulled, then it does not make registering requests at startup.
VEGA RK-2.4/User manual 6 STORAGE AND TRANSPORTATION RULES The VEGA RK-2.4 kit should be stored in its original packaging in heated rooms at a temperature from +5 °С to +40 °С and a relative humidity of no more than 85%.
VEGA RK-2.4/User manual 7 DELIVERY SET VEGA RK-2.4 is supplied with the following configuration: Wireless relay – 1 pc. Reader – 1 pc. RF tag – 0-2 pcs. Battery CR 2032 – 0-2 pcs. Factory certificate – 1 pc. The number of RF tags may vary in depend on the order conditions The number of batteries corresponds to the number of supplied RF tags Revision №...
VEGA RK-2.4/User manual 8 WARRANTY PACKAGE The manufacturer guarantees the functionality of the kit for 3 years from the date of sale. The manufacturer is obliged to provide repair services or replace a failed device within 3 years from the date of sale.