Do you have a question about the SHARK and is the answer not in the manual?
Questions and answers
Terry
July 12, 2025
It won't pump at all. Brand new
Subscribe to Our Youtube Channel
Summary of Contents for OutdoorMaster SHARK
Page 1
SUP ELECTRIC AIR PUMP Intelligent DC Electric Pump OP20“THE SHARK” Operation Instructions Please read the operation instructions carefully before using this product.
OP20 DC12V ELECTRIC AIR PUMP I. Product Introduction Thank you for purchasing this product. The OP20 SHARK is an intelligent DC electric high pressure pump, with a preset pressure LCD screen for choosing the appropriate PSI for your inflatable. This pump can be used for SUPs, inflatable tent etc.
OP20 DC12V ELECTRIC AIR PUMP III. Details of Accessories 6 7 8 Inflation inlet Deflation outlet DC plug Pressure value LCD screen Pressure unit toggle button Pressurizing button Decompressing button On/off button Hose Air tap Gasket H3 valve C7 valve IV.
OP20 DC12V ELECTRIC AIR PUMP - Don’t disconnect the pump with wet hands. - This product shall not be exposed to rain or immersed in water. - In order to avoid risk of injury, the inflation inlet shall not be faced towards face or body.
Page 6
OP20 DC12V ELECTRIC AIR PUMP * Then set desired target pressure using the pressurizing decompressing buttons. The range of pressure value is from 0.5 to 20PSI, (1PSI=0.0689BAR). * After finishing the above steps, press the On/Off button to start to inflation.
OP20 DC12V ELECTRIC AIR PUMP VI. Deflation operation * Remove the hose from the inflation inlet, and then connect it to the deflation outlet instead (see Figure 3). Twist clockwise to tighten it. * Connect the hose end with the air tap to your inflatable’s air inlet valve. * Press the On/Off button to start the deflation.
OP20 DC12V ELECTRIC AIR PUMP VIII. Fault Handling Fault Inspection Solution 1. Make sure that the power wire is plugged e that the 1. The power source is in the 12V DC socket. plugged in the 12V DC socke lved, not plugged properly.
Page 9
OP20 DC12V ELECTRIC AIR PUMP X. Suggestions It’s very important that the air hose is securely connected to the pump interface and SUP without air leaking on either end during the inflating process. This is important in order for the pump to switch from the low pressure motor to the high pressure motor.
OP20 DC12V ELECTRIC AIR PUMP Warranty Policy OutdoorMaster has a 1 year warranty on all its pumps from the date of purchase. OutdoorMaster's 1 year warranty covers any product proved to be defective because of faulty material or product found broken when the customer received it.
Page 11
Diese Pumpe kann auch entleeren. Mit der Luftpumpe können Sie die Luft in Ihrem aufblasbaren Produkt zum Falten und Aufbewahren entleeren. Die OP20 SHARK Hochdruck-Luftpumpe von OutdoorMaster verfügt über ein integriertes aktives Kühlsystem. Achten Sie darauf, dass der Lufteinlass und -auslass, die sich auf der Unterseite der Pumpe befinden, während des Betriebs nicht blockiert sind.
Page 12
OP20 DC12V ELECTRIC AIR PUMP Luftpumpe Schlauch Zubehör Anleitung III.Details des Zubehörs 6 7 8 Inflation Einlass Entleerungsauslass Gleichstromstecker Druckwert LCD-Bildschirm An/aus Schalter Druckeinheit-Umschaltknopf Druckknopf Taste dekomprimieren Schlauch Lufthahn Dichtung H3 Ventil C7 Ventil IV.Sicherheitshinweise - Verwenden Sie diese Luftpumpe nicht, wenn Teile beschädigt sind. Wenden Sie sich für Reparaturen an einen Fachmann.
Page 13
OP20 DC12V ELECTRIC AIR PUMP - Überschreiten Sie niemals den für Ihren Artikel empfohlenen Druck. Andernfalls kann der explodierende Gegenstand schwere Verletzungen verursachen. - Lassen Sie die Pumpe niemals unbeaufsichtigt, während die Pumpe in Betrieb ist. - Lagern oder verwenden Sie die Pumpe nicht in feuchten Umgebungen. - Lassen Sie niemals Sand, kleine Steine usw.
Page 14
OP20 DC12V ELECTRIC AIR PUMP * Während des Aufpumpvorgangs können Sie den Druckknopf oder den Dekompressionsknopf drücken, um den Druckwert zu erhöhen oder zu verringern, die Druckeinheit umschalten, um die Einheit umzuschalten, und die Ein- / Aus-Taste drücken, um anzuhalten. ( Abb1 ) ( Abb2 ) * Wenn der Druck den eingestellten Wert erreicht, stoppt die Luftpumpe...
Page 15
OP20 DC12V ELECTRIC AIR PUMP * Drücken Sie die Taste am Netzschalter der Luftpumpe und starten Sie die Entleerung, bis das gesamte Gas abgelassen ist. Anschließend kann die Stromversorgung abgeschaltet werden, um die Entleerung zu stoppen. ( Abb3 ) VII.Vorsichtsmaßnahmen * Die angelegte Stromquelle muss die 12-V-Gleichstromquelle sein (siehe Abb 4).
OP20 DC12V ELECTRIC AIR PUMP VIII.Fehlerbehandlung Fehler Inspektion Lösung 1.Stellen Sie sicher, dass das Stromkabel in die 1. Die Stromquelle ist nicht 12-V-Gleichstromsteckdose eingesteckt ist. richtig angeschlossen. 2.Sicherung austauschen. Die Luftpumpe 2. Die Sicherung im 3.Kühlen Sie den Motor und starten Sie ihn kann nicht DC-Stecker ist neu.
Page 17
Garantie deckt keine Probleme ab, die verursacht werden durch: Bedingungen, Fehlfunktionen oder Schäden, die nicht auf Materi- al- oder Verarbeitungsfehler zurückzuführen sind. * Wenden Sie sich bitte an OutdoorMaster, indem Sie eine E-Mail an die unten angegebene E-Mail-Adresse senden oder unsere Website besuchen.
Need help?
Do you have a question about the SHARK and is the answer not in the manual?
Questions and answers
It won't pump at all. Brand new