Symbols In This Manual; Environmental Protection; Symbols On The Product - Ryobi R18RS Original Instructions Manual

Hide thumbs Also See for R18RS:

page of 140

/ 140
Contents
Table of Contents
Bookmarks

Table of Contents

Available languages

with plastic parts. They contain chemicals that can

damage, weaken, or destroy plastic.

Always wear safety goggles or safety glasses with side

shields during power tool operation or when blowing

dust. If operation is dusty, also wear a dust mask.

For greater safety and reliability, all repairs should be

performed by an authorised service centre.

GENERAL

Avoid using solvents when cleaning plastic parts. Most

plastics are susceptible to various types of commercial

solvents and may be damaged by their use. Use clean

cloths to remove dirt, carbon dust, etc.

chips and grindings are highly abrasive to bearings,

brushes, and commutators. We do not recommend using

the product for extended periods of time on these types

of materials.

WARNING

Do not use compressed air to blow dust from the product.

This practice is dangerous and can cause dirt and grit to

LUBRICATION

All of the bearings in the product are lubricated with a

the product under normal operating conditions. Therefore,

no further lubrication is required.

ENVIRONMENTAL PROTECTION

Recycle raw materials instead of disposing

of as waste. The machine, accessories, and

packaging should be sorted for environment-

friendly recycling.

SYMBOLS ON THE PRODUCT

Safety Alert

No-load speed

Volts

Direct current

min

Revolutions or reciprocations per minute

-1

CE Conformity

EurAsian Conformity Mark

Ukrainian mark of conformity

Please read the instructions carefully before

starting the product.

Waste electrical products should not be

disposed of with household waste. Please

recycle where facilities exist. Check with your

local authority or retailer for recycling advice.