Teksupply HOVA-BATOR 1602N THERMAL AIR Quick Start Manual

An Incubator is designed to bring normal room temperature to the desired temperature. Room temperture of 60°F. or below will reduce the temperature
in the incubator. Room temperature change of 10°F. or more will change temperature in incubator & is more pronounced below a temperature of
70°F. The location of the machine is important to successful operation. A room temperature from 70° to 80°F. is ideal, and fresh air without drafts is
necessary. Be sure no direct sunlight strikes the incubator and that it sets level. A consistant room temperature within a few degrees is best.
PARTS
Unpack the incubator from box. Use thermostat bracket as
handle to remove the incubator top from inside the bottom,
where it is packed for shipping. Check for the components
listed below.
h ova-Bator Top
W i h t h e t a e e l m e n , t l i p t o g i l h , t
thermostat bracket, & vent
plugs installed.
h ova-Bator Bottom
1825 Thermometer
THERMOSTAT
ADJUSTING SCREW
BRACKET
3006 SNAP
SWITCh
HOVA-BATOR
LOCATION
Wire Floor
THERMOSTAT SETUP
Plastic Liner
Owl Clips x 4
WING NUT
3007 WAFER
1602N THERMAL AIR
NOTE: It is recommended that you operate the incubator with a small quantity of
inexpensive eggs to be assured of your operating procedure and the performance of
h t e n i c u b a o t , r b e o f e r
Keep Reptile eggs protected from moving air. (See Warranty on Page 4).
Install the Plastic Liner and Wire Floor
SETUP UP P UP
Thread wing nut onto
adjusting screw.
Thread adjusting screw
assembly into slot until
enough of shaft is visible
on inside of incubator to
accept wafer.
Thread wafer onto adjusing
screw till it stops, then
w i t h i n c u b a t o r p l u g g e d
in turn adjusting screw
counterclockwise until light
comes on. Keep turning
counterclockwise as needed
to reach desired temp. Allow
the temperature to stabilize
and then adjust as needed.
t a e t m p n i t g o t h a c t h a l g r e q u a i t n e i t s f o
Attach
to Plastic Liner with
Owl Clips then place
Hova-Bator Bottom .
Owl Clip Arrange
the water troughs and
turner
notch as reference.
Fill
Notch
Owl Clip (highlighted
yellow)
water.
not
necessary to prevent it
from drying out.
ADJUSTING Th E
Th ERMOSTAT
Loosen Wing Nut to
make adjustments.
Turn adjusting screw
counterclockwise to
raise temperature &
clockwise to lower.
Re-tighten wing nut
to secure the setting.
The light will come on
t h e t e m p e r a t u r e
for 100
e g g s . A l l o w t h e
incubator to operate
for at least ½ day to
stabilize the setting
before putting in eggs.
e g g s r o e x p e n s v i e e g g . s
Wire Floor
the plastic
power cord
trough #1
in
with warm
Surface area,
depth, effects
when the heat
is on. Adjust
o
F. for most