Advertisement
QUICK START
1
Insert the back of the dome into the base of
the Ferris wheel, then snap the front into place
as shown. Insert the spools of lanyard into the
base.
3
Fill each teacup with different beads. Then,
close the teacup lids.
2
2
BOTTOM VIEW
OF TEACUP
CLOSED
OPEN
Twist the bottom of the teacups until they are
in the closed position.
4
FILL LINE
Spin the Ferris wheel around. When a teacup
is over the dome, twist the bottom of the
teacup to the open position to release the
beads into the dome.
NOTE: Only fill the dome up to the fill line.
5
loop
Thread the lanyard through the loop and
hold both ends between your thumb and
index finger. Pull the lanyard taut without
yanking it.
7
Ask an adult to cut the lanyard off the spool.
Let go of one end of the lanyard and carefully
pull the lanyard through the loop. Grab the
loose ends so that all beads are on one strand.
Double knot the lanyard ends together.
• Remove the dome and turn it over to remove extra beads.
• Add one color bead to the dome at a time and turn the unit on to create bead patterns for your
jewelry. (For example: green, pink, yellow, green, pink, yellow...)
• Thread Lalaloopsy Tinies™ characters onto the lanyard before knotting it.
• Cut the lanyard to the desired length before adding beads to make sure you are using the
proper amount of lanyard.
• To avoid damaging the unit, place only beads in the dome.
• Beads used in the jewelry maker must have a minimum opening of 2.5 mm.
• Store the unit in a safe place to avoid possible damage.
6
ON/OFF
Press the flower button and watch the beads
thread onto the lanyard! Keep the loop and
lanyard centered in the dome opening so that the
beads exit the dome easily. When the lanyard
reaches the desired length, press the flower
button to turn the jewelry maker off.
8
Take your Lalaloopsy Tinies™ along for a ride!
Place them on the pegs inside the teacups
and spin them around!
TIPS
3
Advertisement
