Altox GSM-4 GPS Operation Manual

Altox GSM-4 GPS Operation Manual

Advertisement

Quick Links

General Guide for Installation

- Install the device as far as possible from metal parts and wiring
Altox
harnesses.
- For better receiving of GPS-GLONASS signals direct the upper part of the
device casing to the windshield minding metal obstacles.
- Recommendation: connect device supply directly to the OBD-II connector
wires where pin 16 is +12В, pin 4 is GND (common).
- Analog output AN commutates at GND. It is used to start some heaters
using an analogous signal and to connect status LED located in the button
from the package.
- Auxiliary output OUT commutates at GND. It is used to connect a coolant
pump or the interior's heater via a power relay. It is switched on with the
delay (see SMS-command TIME2) after the heater is switched on. It is
switched off with the delay (see SMS-command TIME3) after the heater is
switched off.
- If you need to implement additional options of remote control of output
OUT (for example, to block engine remotely) activate setting SEPAROUT1.
It switches the output mode into manual control mode (SMS-commands:
O p e r a t i o n a l M a n u a l
ACTIVATE / DEACTIVATE).
In this mode setting KEEPOUT1 activates option to save and to
subsequently restore of output OUT state when the module's power supply
is switched off and then switched on, respectively.
ALTOX GSM-4 GPS
Please indicate the place of ALTOX module's location in the vehicle for
possible maintenance:
Authorized Service:
Installation Date:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the GSM-4 GPS and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Altox GSM-4 GPS

  • Page 1 OUT state when the module's power supply is switched off and then switched on, respectively. ALTOX GSM-4 GPS Please indicate the place of ALTOX module's location in the vehicle for possible maintenance: Authorized Service: Installation Date:...
  • Page 2 Dear buyers of ALTOX equipment! GSM (0-31): 28 - GSM receive signal level (not less than 10) We thank you for purchasing a new ALTOX GSM-4 GPS device. This device Voltage: 12.8V - car-system voltage will provide you with great options to control your autonomous starting...
  • Page 3 The standard ALTOX equipment also includes a button (it is installed if required in the car's interior). This button controls the heater and indicates Note: after the setting of the APN point, ALTOX module will switch into its current working status.
  • Page 4 SMS command SMSW1. If the password is set (PASS:XXXX), then before entering any instruction, 3) In the waiting mode, when the parking heater is switched off, ALTOX you should include its value with no spaces (XXXXSETTINGS1).

Table of Contents