Castolin Eutectic Tri-Safe II Instructions And Parts

Advertisement

Quick Links

®
Tri-Safe
Model II Regulator
INSTRUCTIONS
and
PARTS

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Tri-Safe II and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Castolin Eutectic Tri-Safe II

  • Page 1 ® Tri-Safe Model II Regulator INSTRUCTIONS PARTS...
  • Page 2 USER RESPONSIBILITY This equipment will perform in conformity with the description thereof contained in this manual and accompanying labels and/or inserts when installed, operated, maintained, and repaired in accordance with the instructions provided. This equipment must be checked periodically. Defective equipment should not be used. Parts that are broken, missing, plainly worn, distorted, or contaminated, should be replaced immediately.
  • Page 3 Never discharge fuel gas from a cylinder valve near welding or cutting work, sparks, fl ame, or any other possible source of ignition. Before attaching regulator, remove any dirt or foreign matter that maybe in the cylinder valve outlet by wiping with a clean, lint-free cloth. Valves on other than combustible-gas cylinders may be opened momentarily to blow outlet clean.
  • Page 4 D. Built-in inlet fi lters, to prevent entry of solid foreign matter. E. Gauges, to indicate inlet and outlet pressures. F. A built-in relief valve, to protect the regulator. CAUTION: CYLINDER VALVE CONNECTION MUST MATCH REGULATOR CONNECTION. BE SURE REGULATOR IS USED ONLY WITH GAS SHOWN ON LABEL Figure 1.
  • Page 5 III. OPERATION 3.1 PREPARING FOR OPERATION Once installation of equipment has been completed, (see II INSTALLATION) prepare for operation as follows: Observe precautions in SAFETY Section. Before pressurizing an oxygen regulator, make sure it has been drained of residual gas. While standing off to one side, open the cylinder or upstream valve.
  • Page 6 Except for inspection, troubleshooting, and repairs indicated in this manual, it is recommended that all other servicing be done by Eutectic Corporation. When returning a unit for service repair, the unit should be adequately packaged, in the original shipping container, if possible, and shipped prepaid, with a statement of the observed defi...
  • Page 7 THIS PAGE INTENTIONALLY LEFT BLANK...
  • Page 8 THREE YEAR LIMITED WARRANTY Each new Tri-Safes Model n Regulator is warranted only to the original purchaser to be free from defects in material or workmanship under nor- mal use and service. The obligation of Eutectic Corporation under this warranty being limited to the repair without charge, F.O.B. its factory, or the replacement without charge, F.O.B.

This manual is also suitable for:

Tri-safe 2

Table of Contents