Subscribe to Our Youtube Channel
Summary of Contents for Waterite VELO-FLO
- Page 1 fl fl VELO VELO O O O Automatic Water Bottle Pump Automatic Water Bottle Pump INSTALLATION AND OWNER’S MANUAL www.waterite.com...
-
Page 2: How The System Works
HOW THE SYSTEM WORKS The VELO-FLO Automatic Water Bottle Pump was designed to pump purified water from a 5-gallon purified water bottle. The system will deliver water under pressure to an individual drinking water faucet, the water inlet of a refrigerator for the icemaker and chilled drinking water tap, and to most residential and commercial coffee and tea brewing systems. -
Page 3: Installation
5-gallon bottle close to the pump module, ensuring that the suction hose is free of kinks. VELO-FLO may also be placed in a pantry, closet, cellar or other location where a grounded electrical outlet is available. - Page 4 This device is usually referred to as an inlet pressure regulator or flow restrictor, and limits incoming water pressure to approx. 90-100 psi. If you intend to use the VELO-FLO pump system with one of these brewing machines, you should remove the brewing machine’s inlet restrictor device.
- Page 5 SUCTION WAND INSTALLATION 1. Place bottle close to system and remove bottle cap. 2. Install suction wand into bottle. (Note: If bottle is over filled, dispose of enough water to allow the suction wand to be installed to the bottom of the bottle). 3.
- Page 6 16. Cleaning should be performed at least six (6) times per year. System should be cleaned and flushed with fresh water if unused for more than 48 hours. CAUTION Do not place VELO-FLO into a dishwasher as it will cause electrical failure of pump and controls.
-
Page 7: Temperature Warning
ON position and starting the appliance dispensing valve or the drinking water faucet in order to bleed all the air out of the VELO-FLO. After air has been bled out of the system, close the appliance dispensing valve or the water faucet and the pump will stop automatically until you open the water dispenser valve or water faucet. -
Page 8: Troubleshooting
(1) year after purchase by the customer. During this one (1) year warranty period, Waterite will, at its option and at no charge to the customer, repair or replace this product if found defective in material or workmanship, with a new or reconditioned product.
Need help?
Do you have a question about the VELO-FLO and is the answer not in the manual?
Questions and answers