Summary of Contents for Swiss H33.6
- Page 1 Cooker Hoods Cooker Hoods Cooker Cooker Hoods Hoods Owners Manual Owners Owners Owners Manual Manual Manual...
- Page 2 In particular, check the trouble-shooting guide in the manual (if applicable). The warranty ceases if the Swiss product is damaged by: lightening, water, fire, acts of God, public disturbances, incorrect voltage, normal wear and tear, accident, misuse or abuse, failure to properly maintain, improper cleaning methods, infestation by insects or vermin, incorrect operation, use for which it is not designed (eg.
-
Page 3: Important Safety Information
IMPORTANT SAFETY INFORMATION **Read the complete manual carefully before installation** Intended Domestic Kitchen Only Intended Intended Intended for for Domestic Domestic Domestic Kitchen Kitchen Kitchen Use Use Only Only Only Warnings: TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK OR PERSONAL INJURY, PLEASE OBSERVE THE FOL-LOWING: Installation and electrical work must be done by a qualified person in accordance with all applicable codes and standards... - Page 4 WARNING TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT OF A RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWING: SMOTHER FLAMES with a close-fitting lid, cookie sheet or metal tray, and then turn off the burner. If the flames do not go out immediately, evacuate and call the fire department.
- Page 5 INSTALLATION INSTALLATION INSTRUCTIONS INSTRUCTIONS INSTALLATION INSTALLATION INSTRUCTIONS INSTRUCTIONS Before You Start... 1. Read this manual carefully and completely. 2. The range hoods conform to related appliances standards. Please check your local building codes for any additional requirements. 3. The appliance has been manufactured as class I, there-fore ground connection is necessary.
- Page 6 Installing Installing Ductwork Ductwork Installing Installing the the Ductwork Ductwork 1. Plan where the ductwork will run between the hood and the outside. The hoods exhaust vertically but can be ducted to the rear behind the chimney duct through an outside wall or vertically up through the ceiling to the roof.
- Page 7 Installing Installing Guideline Guideline Installing Installing Guideline Guideline Note: The above installation guideline for references only, please contact local dealer for installation service.
- Page 8 INSTALLATION INSTALLATION ISLAND ISLAND EXTRACTOR: EXTRACTOR: INSTALLATION INSTALLATION OF OF ISLAND ISLAND EXTRACTOR: EXTRACTOR: Step 1. Remove top plate from motor housing (structure) Step 2. Use this plate to mark the celing where you want the extractor to hang from. Step 3.
- Page 9 Step 5. Secure structure to your celing with screws provided. It is advisable, If the celling is not supported well, to use 10mm threaded rods and nuts to secure the structure to the roof trusses. Step 6. Remove all plastic protective film and temporarily put a screw driver into the inner chimney cover.
- Page 10 extractor base(glass head) under and up over the motor structure. More than 2 people are needed to position in place while a 3 person screws the extractor base(ie glass and controls head) to the underside of the motor. (Screws provided. (see next picture) Step 8.
- Page 12 Leveling Leveling Device Device Leveling Leveling Device Device Mounting hood on the wall, the level can be adjusted by turning the two screws on the motor housing. INSTALLATION INSTALLATION ALTERNATIVES ALTERNATIVES INSTALLATION INSTALLATION ALTERNATIVES ALTERNATIVES The cooker hood can be installed in the following ways: Circulating indoor air (A) Outdoor venting (B) REMEMBER!
- Page 13 CARE CARE INSTRUCTIONS INSTRUCTIONS USE AND AND CARE CARE INSTRUCTIONS INSTRUCTIONS Operations Operations Operations Operations For optimum performance in removing cooking odours, it is recommended that you turn on your range hood prior to cooking and you leave it operating for 15 minutes after cooking.
-
Page 14: Button Control
Push button button control control ( ( ( ( For model model H33.6 H33.6 H33.6 / / / / H33.9 H33.9 H33.9 H33.9 / / / / H52.9 H52.9 H52.9 H52.9 / / / / H61.6 H61.6 H61.6 H61.6 / / / / H61.9 H61.9... - Page 15 CARE CARE CLEANING CLEANING CARE CARE AND AND CLEANING CLEANING General General General General Replacing Replacing Replacing Replacing the the charcoal charcoal charcoal charcoal filter filter filter filter � ( ( ( ( optional optional extra extra) ) ) ) optional optional extra extra...
- Page 16 Emptying Emptying cleaning cleaning collector collector (For (For those those hoods hoods fitted fitted with with collector) collector) Emptying Emptying and and cleaning cleaning the the fat fat collector collector (For (For those those hoods hoods fitted fitted with with fat fat collector) collector) The fan is fitted with a fat collector that collects fat from the fan blades and fan housing.
- Page 17 2. Remove the blown halogen bulb (if the fan has 4 bulbs = 10W, 2 bulbs = 20W). Remember that the bulb can be hot! 3. Insert the new halogen bulb. If you touch the halogen bulb with your bare hands this may reduce its service life. Always use a glove or a cloth to avoid direct contact.
- Page 18 Hood Hood Hood Hood Size: Size: Size: Size: Note: Latest launched model dimension might not updated...
- Page 19 Trouble Trouble Shooting Shooting Guide Guide Trouble Trouble Shooting Shooting Guide Guide Problem Possible Reason Solution Check the plug is connected. No electrical supply. Check the main switch is Hood doesn't turn on. turned on. Power cord is damaged Contact technician service Clean the filters and replace Aluminum grease filters clogged when dry.
- Page 20 NOTE: NOTE: Remote Remote Remote is is is is included included included included in in in in certain certain certain models models only. only. NOTE: NOTE: Remote certain models models only. only.