Stillwater Designs KICKER 19119147 Installation Manual

Advertisement

Quick Links

Amplifi er Body Harness
©2012 Stillwater Designs
19119147-A1-20120615
19119147
Designed for 2012 and newer
Chevrolet® Sonic vehicles
Amplifi er/Bracket Assembly
25A Fuse
Wire Ties x6
Amplifi er Power Harness
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the KICKER 19119147 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Stillwater Designs KICKER 19119147

  • Page 1 19119147 Designed for 2012 and newer Chevrolet® Sonic vehicles Amplifi er/Bracket Assembly Amplifi er Body Harness Amplifi er Power Harness 25A Fuse Wire Ties x6 ©2012 Stillwater Designs 19119147-A1-20120615...
  • Page 2 Subwoofer Assembly Subwoofer Power Harness Subwoofer Body Harness 15A Fuse Wire Ties x6 Foam Strip Wire Taps x2...
  • Page 3 Power Wire Routing Cut grommet here. 1. Disconnect the negative battery cable from the battery. 2. Using a razor knife make a cross shaped incision in the large rubber grommet from inside the vehicle and feed the power wire from the engine compartment to the cabin.
  • Page 4 11. Connect the radio speaker/power connecter to the amplifi er body harness and push the connecter up toward the air vents to allow radio enough clearance to be reinstalled. 12. Connect the other end of the amplifi er body harness to the back of the radio and reconnect the other radio connection then reinstall radio.
  • Page 5 Subwoofer Installation 23. Remove the spare tire to retrieve the spare tire safety strap equipped 7” with the vehicle, and then replace the spare tire. (Refer to owner’s manual, beginning in section 10-67, for proper removal and reinstallation of spare tire.) The safety strap will be used to insure the subwoofer enclosure does not become dislodged in the event of a 17”...
  • Page 6 29. With the seatback in the up position set the subwoofer in place Hatchback installation shown against the back of the seatback. Release the seatback and while holding the top of the subwoofer against the seatback slowly rotate the seatback forward until the subwoofer bracket slides under the anchor point on the seatback.
  • Page 7 From Any Speakers Ground wire not grounded properly Check ground wire with voltmeter to insure it is a good ground Low battery voltage Recharge the battery stillwater designs P.O. Box 459 • Stillwater, Oklahoma 74076 • USA • (405) 624–8510...

Table of Contents