Advertisement
CS
CS
CS
In order for the engine to chug with steam,
you have to fill its boiler.
Squeeze and fill the water dropper.
1
BATTERY INSTALLATION
Access the battery compartment by unscrewing and
separating the top half of the engine from the bottom half
of the engine. Install the batteries as indicated inside the
battery compartment. Re-assemble the two halves of the
engine, re-insert the screw and tighten. If the product
begins to malfunction, check the battery installation. You
may need to reset the electronics by removing the
batteries and reinstalling them. If the product continues to
malfunction or no longer operates, remove the batteries
from the toy and replace them with fresh batteries.
Requires 3 "AAA" (LR03) batteries.
FCC STATEMENT (UNITED STATES ONLY)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o
and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Consult the
dealer or an experienced radio/TV technician for help. NOTE: Changes or modi cations not expressly approved by the manufacturer responsible for compliance could void the user's authority to operate the equipment. This
device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
CAN ICES-3 (B)/NMB-3 (B)
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
L'utilisation de ce dispositif est autorisée seulement aux conditions suivantes : (1) il ne doit pas produire de brouillage et (2) il doit pouvoir tolérer tout brouillage radioélectrique reçu, même si ce brouillage est susceptible de
compromettre son fonctionnement.
S1
HOW TO FILL WITH WATER FOR STEAM
HOW TO FILL WITH WATER FOR STEAM
Insert the water dropper into the water hole found next to the engine's funnel. Gently squeeze the water dropper slowly.
Fill the boiler a little at a time to avoid air bubbles, which could inhibit steam production. Stop filling when the boiler is
full. The engine is now ready to puff steam as it chugs along! Do NOT fill the engine's funnel or air vent (refer to the
images provided for correct filling method). After turning the engine on, it may take some time before it starts puffing
steam. After a while, you may need to add more water to produce more steam.
NOTE: It is best to use
COLD distilled water rather
2
than tap water. Tap water
can cause mineral deposits
and effect toy performance.
Never use HOT water.
BATTERY INFORMATION
BATTERY INFORMATION
Required tool:
1,5V x 3
Phillips screwdriver (not included)
"AAA" (LR03)
TRACK LAYOUT
TRACK LAYOUT
S1
X
AIR VENT
CS
D3
D1
S2
WATER HOLE
BATTERY SAFETY INFORMATION
In exceptional circumstances batteries may leak uids that can
cause a chemical burn injury or ruin your product. To avoid battery leakage:
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the product before being charged.
• Rechargeable batteries are only to be charged under adult supervision.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries.
• Do not mix old and new batteries.
• Only batteries of the same or equivalent type as recommended are to be used.
• Batteries are to be inserted with the correct polarity.
• Exhausted batteries are to be removed from the product.
• The supply terminals are not to be short-circuited.
• Dispose of battery(ies) safely.
• Do not dispose of this product in a fire. The batteries inside may explode or leak.
D1
CS
D3
X
FUNNEL
Advertisement
