Advertisement
Precautions before installation (II)
CAUTION
•
Do not install this product where it may:
(i) obstruct the driver's vision,
(ii) impair the performance of any of the vehicle's operating
systems or safety features, including airbags, hazard lamp
buttons or
(iii) impair the driver's ability to safely operate the vehicle.
•
Consult with your nearest dealer if installation requires
drilling holes or other modifications of the vehicle.
•
Before making a final installation of this product,
temporarily connect the wiring to confirm that the
connections are correct and the system works properly.
•
Do not install this product in places subject to high
temperatures or humidity, such as:
- Places close to a heater, vent or air conditioner.
- Places that may be exposed to rain, such as close to the
door or on the vehicle's floor.
Disclaimer
•
Given the large number of variables and conditions that
can be involved in an accident, Pioneer cannot guarantee
that every accident or occurrence will trigger the recording
feature in this device.
•
Pioneer Corporation accepts no responsibility whatsoever
for product failures or damage that occur due to this
product.
24/7 Security Mode
•
If the pre-set operation time elapses when the security
mode is turned ON, the security mode in which parking
surveillance is performed 24 hours per day, 365 days per
year is automatically activated. When this device detects
vehicle movement caused by vibration while the security
mode is activated, that event is saved for the set normal
video time after the moment of detection as a parking
mode file, and a notification message is displayed at the
next startup.
English
Notes
•
The security mode can be set to on or off.
→ "This Product Settings" - "Configurable Features" -
"Parking Mode" - "Security mode"
•
In the security mode, this product runs in the low power
consumption mode to reduce the risk of the battery
running flat.
•
When the battery voltage drops below 11.2 V, security
mode standby and recording are stopped.
•
The security mode starts recording within three seconds of
detection of impact.
•
Vibration that is detected for approximately three minutes
before the vehicle's engine is turned on (ACC ON) is not
covered by the notification message display feature.
•
The security mode is a feature for starting up and
activating this product after an impact is detected. For this
reason, the battery might wear more quickly if this product
is used in mechanical multi-story parking garages or
location subjected to lots of vibration. When parking in
locations such as these, set the security mode to off before
using this product.
•
The parking mode (security mode allowing 24-hour, 365-
day surveillance) can be used by extracting
power directly from the vehicle by the power / AV cable.
You can also connect the product to navigation by the
power / AV cable to project realtime video from this
product or movies and photos that are being played back
on the screen of the navigation.
Advertisement
