Page 2
Control Panel ......2 Dishwasher Features ....2 Wash Cycle Table .
Page 3
HYDROGEN GAS IS EXPLOSIVE. If the hot-water system has not been used for such a period, before using the dishwasher turn on all hot-water faucets and let the water flow from each for several minutes. This will release any accumulated hydrogen gas.
To get the best performance from your dishwasher,read all operating instructions before using it for the first time. 1 2 3 4 1 Pre-rinse light: Blink during pre-rinse. 2 Wash light: blink during w ash. 3 Rinse light: b link during rinse.
When you close the door and press the Start/Reset button, the machine will keep on working after 10 seconds. The four program lights shows the state of the dishwasher: a)All program lights off-----------------stand by b)One of the program lights on-----------pause...
There are two ways to reduce the detergent. The hardness of the water varies from place to place. If hard water is used in the dishwasher, deposits will form on the dishes and utensils. The appliances is equipped with a special softener that uses a salt specifically designed to eliminate lime and minerals from the water.
Also, more heavily soiled items need more detergent. Always add the detergent just before starting dishwasher, otherwise it could get damp and will not dissolve properly. IF THE WATER ISN'T TOO HARD, YOU MAY ALSO PREVENT THE FORMATION OF DEPOSITS B Y ADDING DETERGENT.
Page 8
If there is no rinse aid warning light in the control panel, you can judge the amount of rinse aid by the following means. The black dot on the rinse aid dispenser indicates the amount of rinse aid in the dispenser. As the rinse aid diminishes, the size of the black dot decreases.
Page 9
When the working cycle has finished, the buzzer of dishwasher will mooing 8 second ,then stop . Turn off the appliance using the ON/OFF button, shut off the water supply and open the door of the dishwasher.
For your convenience, we have placed the drain pump and filtering system within easy reach inside the tub. There are three components of the filtering system: the main filter, the coarse filter, and the fine filter. If your dishwasher is left in an unheated place during the winter, ask a service technician to: Uncrew It is necessary to cl ean the spray arms regularly for hard water chemicals will clog the spray arm jets and bearings.
Page 11
Before cleaning or performing maintenance, always remove the plug from the socket. Do not run risks. To clean the exterior and rubber parts of the dishwasher, do not use solvents or abrasive cleaning products. Rather, use only a cloth and warm soapy water.
Page 12
Turn water fully on before starting the dishwasher. A hose that attaches to a sink spray can burst if it is installed on the same water line as the dishwasher. If your sink has one, it is recommended thet the hose be disconnected and the hole plugged.
Position the appliance in the desired location. The back should rest against the wall behind it, and the sides, along the adjacent cabinets or wall. The dishwasher is equipped with water supply and drain hoses that can be positioned to the right or the left to facilitate proper installation.
To ensure everything is secured in the dishwasher. Dishwasher has not been used regularly. If you do not use it often, remember to set it to fill and pump out every week, which will help keep the seal moist.
You have to call a water softener company for a special filter. To clean the interior, use a damp sponge with dishwasher detergent and wear rubber gloves. Never use any other cleaner than dishwasher detergent for the risk of foaming or suds.
Need help?
Do you have a question about the CSD 68-80 and is the answer not in the manual?
Questions and answers