Advertisement
Replacing the LED Unit
The LED unit can be replaced by pulling the lens unit out of the contact block.
Contact Block
Orientation of the LED unit
Insert the LED unit into the contact block with the TOP markings on the contact
block and LED unit in the same orientation.
TOP
Notes on replacing the LED Unit
• When replacing the LED unit, make sure that static electricity is not applied.
• Make sure that the LB series has cooled down before replacing the LED unit.
• To avoid getting burned, be careful not to touch the unit while it is still hot.
Notes on Using Quick Connect Terminals
1. U se #110 tab quick connects, 0.5 mm-thick.
2. When connecting the terminals on the left and center, make sure that
surfaces of the quick connects face each other. Otherwise, a short-circuit may
occur.
TOP
Correct
3. A pply only horizontal force against the panel to the tab. The switch may be
damaged if a force other than a horizontal force is applied.
Switches & Pilot Devices
LED Unit
TOP
TOP
Incorrect
800-262-IDEC (4332)
•
USA & Canada
Installing Rubber Boots
When using the switches in enviroments subject to splashing water or an exces-
sive amount of dust, make sure to use an optional rubber boot.
As shown in the drawing below, j remove the gasket from the operator, and k
attach the rubber boot from the front (button side).
Standard Bezels
For rectangular and square units, pull out the seals of the rubber boot and place
them around the operator sleeve as shown below. Make sure that the seals are
not twisted or tucked inside and that the gasket is removed, otherwise water-
proof and dustproof characteristics are not ensured.
How to Install the Rubber Boot
Rectangular
Seals
Seals
Mount
Gasket
Square
Seals
Seals
Mount
Gasket
Round
Operator
Mount
Gasket
ø16mm - LB Series
Operator
Remove
Rubber boot installed
Operator
Remove
Rubber boot installed
Remove
Rubber boot installed
499
Advertisement
