Page 1
Quick Start Guide for Magnum Shut-N-Cut #1901-26-01 *You will need a #3 Phillips head screwdriver and a 7/16” (11mm) socket or wrench. Please Review and Verify Parts Included in Box: 1. Clamp Assembly Item B 2. Base 3. Knife Kit 4.
Page 2
INSTRUCTIONS FOR USE • Pull back on the red-capped Lock Lever to unlock the Clamp Arm. Pivot the Clamp Arm to the full-open position. • Set insulation on the lower Clamp Bar so that the cutting slot is in-line with the desired cut. Insert knife in slot • Close the Clamp Arm to compress the product, pressing down until the Lock Lever engages. • Insert the EZ Insulation Knife (included) into the cutting slot on the Clamp Arm. • Cut through the insulation product with a sawing motion, drawing the blade toward you.