BLUE SKY PFP1513-WJ Owner's Manual page 6

ASSEMBLY
NO TOOLS REQUIRED!
STEP 1
Make sure the fire pit is a safe distance from all combustible materials.
If using directly on the ground, level the area with a rake if necessary
and remove any dry grass or overhanging branches. Also, remove any
overhanging branches or other materials that could create a fire hazard.
STEP 2
Place the burn chamber [A] on top
of the ash catch stand [B] and press
down firmly to fit in place.
STEP 3
Insert the loop into the center hole on
the spark screen [C] and secure it with
a nut on the other side. Assemble the
screen lift [D] by screwing the two
pieces together.
Cover the fire pit with spark screen at
all times when in use. Use the screen
lift to add or remove the spark screen.
STEP 4
Fill the Burn Chamber approximately 5 cm (2") deep with wood pieces or
pellets. As the fire dies down, slowly replenish with additional wood pieces
or pellets. Note: If you refill with too many wood pieces or pellets too
quickly, there will be excessive smoke until they properly ignite.
When finished with your fire, just let the flames burn out. The ash catch
stand easily fits inside the burn chamber for easy storage. The fire pit should
be put away and stored indoors when not in use. However, make sure the pit
has completely cooled before handling and storing.
6