Shivaki SH WH 2.0 100 User Manual page 16

6.2.2. Set anchor bolts in prepared holes, check the strength of their mounting. The position
of hooks of anchor bolts in the wall should prevent spontaneous movement of water heater
brackets on them.
6.3. Connection to water supply.
ATTENTION! In order to provide long operation life of the tubular electric heater, it's
recommended to use filter for water pre-treatment
6.3.1. Install the safety check valve on cold water inlet, marked with blue ring, for 3.5 to 4 turns,
ensuring the tightness of the connection by any water-sealing material
NOTE:
– During operation of the water heater, you can observe occurrence of drops from the outlet of safety check valve
(relief of excess pressure during water heating). It's recommended to connect rubber or silicone pipe of corresponding
diameter to the drainage hole for moisture draining.
6.3.2. Perform connection to water supply in accordance with the Pic. 1 with copper, metal-plastic
or plastic pipes, as well as special flexible plumbing connecting pipes. Please do not apply excessive
force during mounting to avoid damage of cold and hot water nipples.
IT'S PROHIBITED to use flexible connecting pipes used previously!
IT'S PROHIBITED to operate the water heater without safety check valve or use valve of
other manufacturer not conforming the requirements to water pressure
REQUIREMENTS AND PRECAUTIONS)
Body
Outlet pipe for hot water
Coupling tee
Pic. 1. General layout of water heater connected to water-intake point
16
!
Model Model
WH TT WH
Mixer
Storage capacitor
(not in the delivery set).
Thermometer
Power cord
Safety check valve
Outlet hole
Water inlet valve
(hemp, PTFE tape, etc.).
(see SAFETY
Safety check lever
Outlet hole of the safety check
valve
Water inlet valve
Water pipe
.