Aroma360 Mini360 2.0 Instructions

Mini360 2.0 Instructions:

Setting the Current Time

Note: If a button is NOT pressed within 4 seconds or less when setting your current time and events, the
time will revert to the previously displayed time.
1. To set the current time, press SET once, and the hour will flash. Press UP or DOWN to adjust to
the current hour and press set to confirm your choice. (If your screen is unresponsive, press and
hold the SET button for 20 seconds and try again after you hear it beep)
2. Press SET The minutes will now be flashing. Press UP or DOWN to adjust to the current minute.
3. Press SET for a 3
Press UP or DOWN to adjust to the current day of the week (press SET for the 4

Setting the Operating Hours

Now it's time to set your event operating periods. The diffuser you have allows up to five individual
event operating periods so you can scent at various times on different days of the week. We
recommended from 4-6 hours per day since this Mini with Wi-Fi has a 5,000-6,000 hour motor life.
To set the start time of an operating period:
1. Press MODE. EVENT 1 ON will appear. This represents the ON time for the first working period.
Set time as instructed above – press SET and the hour will flash. Press UP or DOWN to adjust.
Then press SET again for the minutes to flash, press UP or DOWN to adjust the minutes.
Example – 07:30 = 7:30am / 19:30 = 7:30pm
To set the operating days:
1. Press SET for a 3
week. The day of the week will begin to flash while going through each day of the week you
desire to have the settings adjust to.
2. While going through each day of the week, you will then press the UP button to select whether
you wish to have that day of the week off for this event (press UP again to add it).
Example: if you wish to have Mon – Fri for EVENT 1; you will go through each day of the week to
be sure a box symbol is displayed through only those days. To Remove the symbol, select the day
of the week you wish to remove and then press the UP button again to make the symbol
disappear (deactivate) on that day.
To set the end time of the operating period:
1. Press MODE. EVENT 1 OFF will appear. This represents the Off Time for the first operating
period. Press UP or DOWN to adjust the hour, press SET to confirm.
Ensure there are no conflicting settings.
rd time to adjust the day of the week; now the day of the week will be flashing.
rd time (during the ON session), then tap the DOWN button to each day of the
th time to save it)