Advertisement
7. Push crotch portion of seat pad inside out to form seat, so the fabric is on
inside of pad.
8. Insert the 8 round tabs on the seat pad into slots located around the seat
ring, slide tabs through holes. Turn tray up side down. Pull tabs and align
into grooves. You may have to push tabs from top of walker to properly
fasten. Ensure that all 8 tabs have clicked over the grooves.
9. Test: Push down hard on seating area of seat pad to make sure seat is
securely in place.
CAUTION:
properly, otherwise child may fall through walker.
10. Place walker on a solid flat surface with bottom of base facing upward.
Insert the pins of the wheels into their housing, pressing them until they
snap into position. Please check that wheels are locked into place as
Figure 9
and Figure 10 .
Figure 6
Figure 6
4
Assembly
Do not use walker if all tabs are not secured
Figure 7
Figure 9
Figure 10
Assembly
11. Turn base up side down, insert the grip pads properly with middle post and
the both side post as Figure 11 . Be sure all 6 Grip Pads are attached to the base
securely before use.
12. The baby walker can be used for 3 different heights. To adjust heights,
remove baby from walker. Turn the safety button lengthwise and press the
safety button until the mechanism is released. Adjust to desired height as
shown in Figure 12 .
13. When the position has been selected, check that the safety button turned
through 90 degrees to prevent the accidental release of the
mechanism as shown in Figure 13 .
NEVER USE THE BABY WALKER IF THE BUTTON IS NOT IN THE SIDEWAYS
POSITION. IMPORTANT:
Never change the height when the baby is in the
walker.
14. To compact the walker, turn upside down and turn safety button
lengthwise and push down to lowest level.
15. Toy tray requires 2 "AA" batteries (not included). Please use Philips head
screwdriver to unfasten battery cover. Insert battery as Figure 14 . Secure
battery cover back.
Caution:
Old and new batteries (alkaline standard or
rechargeable) should not be mixed in use. Remove battery before storing
the toy tray.
Figure 11
90˚
Figure 13
ALWAYS FOLLOW THIS PROCEDURE.
Figure 12
Figure 14
5
Advertisement
