PROCEDURES TO TAKE DURING GAS ALARM
1. Turn off all Gas appliances (Stove, Heater, Furnace,
Refrigerator, etc.), extinguish all flames and smoking material.
2. Press the Test/Mute switch. DO NOT DISCONNECT
POWER
3. Evacuate the RV. Make sure everyone is accounted for.
Leave the door and windows open.
4. Turn off the propane tank valve.
5. Determine and repair the source of the leak. Get professional
help if necessary. CAUTION- DO NOT RE-ENTER UNTIL
THE PROBLEM IS CORRECTED.
PROCEDURES TO TAKE
DURING A CO ALARM IN THE USA
!
WARNING
: Actuation of this device indicates the
presence of carbon monoxide (CO) or propane gases, which
can KILL YOU. If signal sounds (4 beeps and flashing or
solid red light): 1) Operate the Test/Mute button; 2) Call your
emergency local service (Phone Number _____________ )
(fire department or 911); 3) Immediately move to fresh air -
outdoors or by an open door/window. Check that all persons
are accounted for. Do not reenter the premises or move away
from the open door / window until the emergency responders
have arrived, the premises have been aired out and your alarm
remains in its normal operation. 4) After following steps 1-3,
if your alarm reactivates within a 24-hour period, repeat steps
1-3 and call a qualified appliance technician. (Phone Number
_______________) to investigate for sources of CO from fuel
burning equipment and appliances, and inspect for proper
operation of this equipment. If problems are identified during
this inspection have the equipment serviced immediately.
Note any combustion equipment not inspected by the
technician and consult the manufacturers' instructions, or
contact the manufacturer directly, for more information about
CO safety and this equipment. Make sure that the motor
vehicles are not, and have not been, operating in an attached
garage or adjacent to the residence.
PROCEDURES TO TAKE
DURING A CO ALARM IN CANADA
!
WARNING: Actuation of this device indicates the
presence of carbon monoxide (CO) and propane gases which
can KILL YOU. If signal sounds (4 beeps and flashing or solid
red light: 1) Operate the Test/Mute. Immediately move to fresh
air - outdoors or by an open door/window. Check that all
persons are accounted for. Do not reenter the premises or move
away from the open door/window until the emergency
responders have arrived, the premises have been aired out, and
your alarm remains in its normal condition; 2) call your
emergency local service (telephone number _________) ( Fire
department or 911).
End of Life Signal – The Sensor has a 5 Year Service Life
All 70 Series models include an End of Life (EOL) Signal indicating
the sensor has reached the end of its service life and you must
replace the alarm. The signal is the LED flashing RED RED
GREEN GREEN with a beep every 25-30 seconds. The EOL Signal
may be reset by pushing TEST / RESET button on the alarm. This
will reset the EOL Signal for a period of 72 hours (3 days) for a
total of up to 30 days. After 30 days the signal cannot be reset and
the alarm must be replaced. DO NOT DISCONNECT THE
ALARM UNTIL YOU HAVE A REPLACEMENT ALARM
AVAILABLE TO INSTALL.
SPECIFICATIONS
MODELS
POWER SUPPLY
NOMINAL CURRENT DRAW
OPERATIONAL TEMPERATURE
RELATIVE HUMIDITY
AUDIBLE OUTPUT
GAS ALARM TRIGGER
GAS LEVEL CONFIRMATION
CO ALARM TRIGGER
CASE DIMENSIONS
WARRANTY
TESTING LABORATORY
STANDARD
LIMITED PRODUCTS WARRANTY
MTI INDUSTRIES, INC. warrants to the original retail purchaser that its
products will be free from defects of material or workmanship for a period
of One (1) year from the date of retail purchase. If proven to have been
defective in original materials or workmanship and returned, delivery costs
prepaid, MTI INDUSTRIES, INC. will replace this product free of charge.
LIMITS OF WARRANTY
Replacement is your exclusive remedy under this limited warranty or any
other warranty (including any implied warranty of merchantability for a
particular purpose). Any and all implied warranties or merchantability or
fitness for a particular purpose shall be limited to the warranty period from
the original date of retail purchase. MTI INDUSTRIES, INC., its dealers
and distributors shall in no case be responsible or in any way liable for any
incidental or consequential damages for any reason. Some states do not
allow the limitation or exclusion of incidental or consequential damages, or
allow limitations on how long an implied warranty lasts, so the above
limitations may not apply to you. This warranty gives you specific rights,
and you may also have other rights, which may vary, from state to state.
70-742, 70-742-R-Kit
12 VDC
108 mA (1.6 Amps with Solenoid Valve)
o
o
o
o
-40
F to +150
F
-40
C to +66
C
15% (+/- 5%) to 95% (+/- 4%)
85 dB @ 10 feet
< 25% of the LEL of Propane and Methane
8 Second delay before alarm
4 -15 Minutes @ 400 ppm
6.5"W x 3.5"H x 1.38"D
1 Year Limited
Underwriters Laboratories
UL 1484, Fourth Edition
UL 2034, Third Edition
Need help?
Do you have a question about the 70 Series and is the answer not in the manual?