ccei LIMPIDO Z Quick Start

LIMPIDO Z : QUICK START
QUICK START OF THE DEVICE :
ENTER ELECTROLYSE MENU
For a quick and efficient start of the electrolysis system, use the mode Production=ON. This mode will allow to
control the device together with the filtration system.
For a more precise electrolysis, use the mode Production=REG which will allow to control chlorine
Z3
production according to pool RedOx. See the instructions leaflet, on page 12 to buffer the RedOx probe and
Only
to set the RedOx set value
ENTER pH MENU
Set regulation on pH Dosage ph = pH- to bring pH down.
Set regulation on pH Dosage ph = pH+ to bring pH up.
The pH=ON mode is a continuous functioning mode which must be used only for pump priming.
NEVER LEAVE THIS SETTING ON, otherwise the pH bottle would empty quickly.
The device is provided with a safety on pH injection, which allows to set a maximum daily volume not to be
exceeded. For example, in a 40m3 pool, a daily dose of 0.3 litre/24h is enough. This setting can be done in the
pH menu: V/24h=0.3L.
HIGH OR LOW SALT LEVEL WARNINGS & BACKWASH
SHORT FILTRATION POWER CUTS :
Warning : short power cuts (less than 1 minute) on the filtration pump or on 230V may lead to default of
the device. This default stops chlorine production but is not harmful to the device
When you face « lack of salt » of « high salt level », cut off the device for 5 minutes, then restart
the device after checking the electrolysis setting is not OFF . This operation can be enough to remove
the warning. If the default remains, check the real salt level into the pool as described in page 6 of the
user's guide.
IN CASE OF BACKWASH :
Turn off the device while backwashing the filter. The device should remain turned off during backwash
(5 minutes)
USING INSTRUCTIONS
Sonde pH
pH probe
Sonde ORP
ORP probe
For a correct setup of the probes, use
Injection pH
ZELIA-POD and connect the ground socket
pH injection
of the ZELIA-POD on a ground rod which
is independent from the safety ground
PoolTerre intégré
equipment of the house. This independent
Earthing device
ground system must be as good as pos-
sible in order to increase the efficiency of
the probes (reading and lifetime).