Bosch Rexroth RE 07009-MON General Assembly Instructions page 12

12/20 Bosch Rexroth AG
WARNING!
Assembly Instructions for Hydraulic Power Units | RE 07009-MON/11.17
5.1.6 Transport using cranes and similar lifting tools
Danger to life due to falling or uncontrolled movement of the hydraulic
power unit!
If not transported appropriately, the hydraulic power unit may be knocked, fall or
move in an uncontrolled way.
When using lifting tools, ensure a stable center of gravity position.
f
The hydraulic power unit must not deviate from its intended orientation. If
f
necessary, attach suitable safety and/or catch devices.
If using cranes as a means of transport, attachment device e.g. lifting straps,
harnesses or chains should be used.
Use only the intended locations and attachment points when lifting (see Fig. 5
f
and 6).
Ensure that the built-on components of the hydraulic power unit do not come
f
into contact with the attachment device or lifting tools during transport.
The edges of the hydraulic power unit may cause damage to the fabric lifting
straps or harnesses. An edge protector should therefore be used if necessary.
When using uncovered chains, scratches in the paintwork may result. If
necessary, use suitable protection for these surfaces e.g. blankets.
Lift and lower the hydraulic power unit slowly and carefully.
f
Only lift the device as far off the floor as necessary.
f
Fig. 5: Use of lifting straps and attachment points