Gainsborough Pk2 Solar Butterfly Stake Assembly Instructions

Pk2 Solar Butterfly Stake
H305
v01: 13/11/20
Please read and retain these instructions for future reference
ALWAYS POSITION IN DIRECT SUNLIGHT FOR BEST CHARGING
Dimensions:
23 x 10 x 109cm
Stake – 0.8cmD x 55.5cmL

BREATHTAKINGLY COLOURFUL THESE BUTTERFLY STAKES
WILL REALLY BRING YOUR GARDEN TO LIFE

WITH DECORATIVE WINGS THAT ARE A MIX OF GLASS AND
METAL, BEADED BODY AND PRETTY LEAF DÉCOR ON THE
STAKES

GIVES A REAL BURST OF COLOUR AND AT NIGHT TIME
AUTOMATICALLY LIGHT UP TO GIVE A MAGICAL GLOW

PLACE ALONG A PATH, IN POTS OR AMONGST YOUR
FLOWERS BEDS

LEDs not replaceable
Battery: 1x Ni-MH AAA 300mAh 1.2V rechargeable battery

ASSEMBLY INSTRUCTIONS / INSTRUCTIONS FOR USE:

Unpack the components carefully. Please check all parts have been
removed from the packaging.
To easily insert stakes into the ground, it is recommended to wet
the ground first. To avoid damaging garden stakes when inserting
into the ground, select a spot in soft, rock-free soil. Insert the base
of the stake first then gently insert the rest of the stake into the
base. DO NOT push directly against the solar cell or the ornament
housing containing the actual LED light.
Before using first time
Allow lamp to charge for at least 8 hours in full sunlight with the
ON/OFF switch in the ON position. The ON/OFF switch is located
under the solar panel. Once the batteries are fully charged, set the
ON/OFF switch to ON. If the lamp does not turn on after dark refer
to Maintenance section.