Mercedes-Benz CLA Owner's Manual page 142

Changing the front bulbs (vehicles with halo‐
gen headlamps)
Fitting/removing the cover on the front
wheel arch
Requirements:
The lighting system is switched off.
R
The appropriate front wheel is turned
R
inwards.
To remove: turn cover 1
#
remove it from the wheel arch liner.
To install: insert cover 1
#
arch liner and turn it to the right until it
engages.
Replacing bulbs in the halogen headlamp
Requirements:
Dipped beam: a H7 55 W light bulb is availa‐
R
ble.
Highbeam: a H7 55 W light bulb is available.
R
1
Dipped beam housing cover
2 Main beam housing cover
to the left and Switch the lighting system off.
#
Remove the cover in the front wheel arch
#
( page 139).
into the wheel
/
Turn the relevant housing cover anti-clock‐
#
wise and remove it.
Turn the socket anti-clockwise and remove it.
#
Pull the bulb out of the socket.
#
Insert the new bulb into the socket such that
#
the entire base of the bulb is resting on the
bottom of the socket.
Insert the socket and turn it clockwise.
#
Press on the housing cover and turn it clock‐
#
wise.
Replace the cover in the front wheel arch
#
( page 139).
/
Changing the rear bulbs (vehicles with halo‐
gen headlamps)
Replacing the tail lamp bulbs
Due to their locations, have the bulbs for the
#
turn signal light and reversing light changed
at a qualified specialist workshop.
Light and sight 139