ABB TZID-C Quick Start page 2

6. Start Autoadjust:
• Press and hold MODE
• In Addition briefly press
• Release MODE.
• Press ENTER and keep it pressed until the countdown from 3 to 0 is finished.
• Release ENTER Autoadjust is now activated; the complete process will take a few minutes.
• When the message "COMPLETE" is displayed to indicate successful Autoadjust, briefly press ENTER to
acknowledge. It is also possible that Auto-adjust is cancelled due to errors detected during this procedure; the
applicable error message is displayed. Refer to Instruction manual for error codes and details.
7. Save the settings:
• Press and hold MODE.
• In addition, briefly press
• Release MODE.
• Select NV_SAVE using
• Press and hold ENTER until the countdown from 3 to 0 is completed, then release ENTER. The settings are
saved in the non-volatile memory, and the positioner returns to the operating level.
Selecting the Operating Mode
Mode 1.1: Fixed control
• Press and hold MODE.
• Additionally briefly press
• Release MODE
• Positioner is now active in the FIXED control mode.
Mode 1.2: Adaptive Control
• Press and hold MODE.
• Additionally briefly press
• Release MODE
• Positioner is now active in the ADAPTIVE control mode.
until "P1.1" is indicated.
until P1.4 "EXIT" is indicated.
or .
as often as required until level 1.1 "CTRL_FIX" is displayed.
as often as required until level 1.2 "CTRL_ADV" is displayed.
QUICK-START