Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Mac Afric SSAWRP-002
-
Page 2: General Power Tool Safety Warnings
protected supply. Use of an RCD reduces the risk of electric shock. GENERAL POWER TOOL SAFETY WARNINGS NOTE: The term “residual current device (RCD)” may be replaced by the term “ground fault (For All Power Tools) circuit interrupter (GFCI)” or “earth leakage circuit breaker (ELCB)”. WARNING! Read and understand all instructions. -
Page 3: Intended Use
before making any adjustments, changing accessories, or storing power tools. Such Intended Use preventive safety measures reduce the risk of starting the power tool accidentally. 20. Store idle power tools out of the reach of children and do not allow persons unfamiliar with The machine is intended for sawing wooden materials, plastic, metals and general building the power tool or these instructions to operate the power tool. -
Page 4: Additional Safety Rules
13. Recycle and use the damaged tools, accessories and abandoned packages in an ADDITIONAL SAFETY RULES environmentally friendly way in accordance with the local laws. Hold tool by insulated gripping surfaces when performing an operation on wall and SAVE THESE INSTRUCTIONS. floor where the cutting tool may contact hidden wiring. -
Page 5: General Descriptions
13. Keep work area well-ventilated. Improper use of battery or damaged battery may send GENERAL DESCRIPTIONS out toxic gases, which can cause personal injury. 14. Overheating or overusing of the battery may cause liquid escape and come into contact with the adjacent components. Clean such parts or replace them, if required. If electrolyte contacts with your skin, wash the contacted area with soap firstly and then wash with lemon juice and vinegar. -
Page 6: Battery Indicator
Battery Indicator servicing life of the battery or cause the battery unable to be charged. CAUTION: To achieve best performance, a new battery cartridge or a battery cartridge not used for a long time should be charged and discharged for 3 to 4 cycles. The four charging lights may flash in red color if the tool is overheated or overloaded. - Page 7 FFCL18-01 SCHARG-001 Model FFCL18-03 (FFCL18-04) 2. Charging Operation Input Voltage (AC) 220-240V 110-240V The battery charger can detect some sort of Charging Current 3.0A Input Power Frequency 50-60Hz failure caused by the battery and indicates by the Applicable Battery Cartridge Voltage statuses of the red and green indicator lights.
-
Page 8: Tips For Operation
Operation Selecting Saw Blade Use only saw blades suitable for the material being worked. Select a suitable saw blade CAUTION: according to the workpiece in reference to the table as mentioned in intended use. The saw Lock the safety switch if the tool is not in use. blade should not be longer than required for the intended cut. -
Page 9: Plunge Cutting
If the saw blade should jam, switch the machine off immediately. Widen the gap somewhat with a suitable tool and pull out the machine. When sawing metal, coolant/lubricant should be applied alongside cutting line because of the material heating up. Do not expose battery cartridge to rain, snow or wet conditions. - Page 10 EXPLANATION OF GENERAL VIEW Saw blade Needle Bearing Rubber Sleeve Spindle Sleeve Left-half Handle Needle Bearing Right-half Handle Bearing Retainer Damping Ring Gear Retainer Terminal Block Latch Switch and PCB Assembly Driven Spiral Bevel Gear Rubber Pin Washer Switch Spindle Safety Switch Iron Damping Spring A...
Need help?
Do you have a question about the SSAWRP-002 and is the answer not in the manual?
Questions and answers