Page 4
A light source, attached to one leg of the Y6 Yoke, is Y6 Yoke activated by the magnetic field and switches on auto- Serial Number: matically during testing.
DO NOT smoke while performing Non Destructive Testing (NDT). Max. working Description temperature • DO NOT operate the Y6 Yoke for longer than 3 seconds ON followed by 10 seconds MAGNAVIS dry powders have closely- OFF (i.e. a 23% duty cycle). MAGNAVIS 1 Grey ®...
Cable cover 17771A3 The Y6 Yoke is designed to be used in conjunction with appropriate chemicals as a means WARNING: DO NOT REPLACE ANY PARTS WITH ANYTHING OTHER THAN THOSE of non-destructive testing (NDT) for defects, such as cracks, on a wide range of manufac- RECOMMENDED BY MAGNAFLUX.
TECHNICAL SPECIFICATION ELECTRICAL Ensure that the protective conductor (earth) is continuous from the Y6 laminations through suitable connections to the electrical supply. Part number 001Y022 001Y004 001Y013 001Y020 AC voltage (V) Recommendations: Frequency (Hz) • If the supply to the Yoke is greater than 50V, use a Residual Current Circuit Breaker (RCCB) or Earth Leakage Circuit Breaker (ELCB).
To detect transverse cracks in mounted spindles, rear axles and other light parts, the Y6 • Familiarise yourself with the yoke’s construction and method of operation. If necessary, Yoke can be supplemented by a magnetising coil (e.g. Magnaflux L-10 Magnetising Coil). contact the manufacturer - Magnaflux GmbH - for instruction/training. •...