Summary of Contents for Everlasting Comfort HD-008
- Page 1 Heavy-Duty Boot Dryer User Manual READ AND SAVE THESE INSTRUCTIONS Inspect Unit Before Use. Contact support@upperechelonproducts.com immediately for any damaged or defective units.
- Page 2 TABLE OF CONTENTS COMPONENTS MAINTENANCE SAFETY HELPFUL TIPS OPERATION TROUBLESHOOTING SPECIFICATIONS 1. COMPONENTS HELMET STRETCHER SHOE STRETCHER BACK DRYING TUBES FRONT DRYING TUBES HEAT/NO HEAT SWITCH TIMER KNOB LOCKING BUTTONS OZONE SWITCH BLOWER ASSEMBLY MAIN BODY BASE DRIP TRAYS Fig. 1 FRONT VIEW...
- Page 3 FRONT DRYING TUBES SHOE STRETCHER BACK DRYING TUBES BLOWER ASSEMBLY POWER SUPPLY CORD CORD HOLDER DRIP TRAYS Fig. 2 BACK VIEW 2. SAFETY PLEASE READ CAREFULLY BEFORE USE & SAVE THESE INSTRUCTIONS WARNINGS ONLY FOR USE IN A WELL VENTILATED AREA. DO NOT use on any carpeted surface.
- Page 4 WHEN USING AN ELECTRICAL APPLIANCE, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE OBSERVED, INCLUDING THE FOLLOWING: Thoroughly inspect the unit in its entirety for any cracks, chips, or damage that could cause the unit to malfunction. DO NOT use if damage is found. Only a professional or authorized repairman should repair this appliance.
- Page 5 3. OPERATION Attach 4 drip trays to the bottom of the unit. Press Attach either the 2 interchangeable shoe or helmet the tray onto the bottom feet of the unit and turn stretchers to the back drying tubes. the tray clockwise to secure it in place. Adjust the height of the drying tubes: Plug the boot dryer into any standard 120 Volt 60 Hz electrical outlet.
- Page 6 Turn the timer knob clockwise to the 180-minute To sanitize and deodorize your footwear or garment, mark to activate the timer switch, then turn the flip the Ozone switch to the ON position. knob counterclockwise back to the desired drying time.
- Page 7 You may have received a defective Shut it down immediately and or burning odor. unit. disconnect the power plug. Any repairs must be done by a professional repairman. 7. SPECIFICATIONS Model No. HD-008 Voltage 120V 60Hz 250 W Power Capacity 4.0L Conforms to UL STD.499 CSA STD.C22.2 No.64...
- Page 8 5003917 All parts have been tested by Intertek and are ETL Certi ed.
Need help?
Do you have a question about the HD-008 and is the answer not in the manual?
Questions and answers
no heat not much air flow
The Everlasting Comfort HD-008 may not seem like it is producing heat because the warm air it emits is gentle. To check, place the back of your hand near the drying tubes or place garments on the tubes for 30 minutes and then feel inside. If the unit is still not producing heat or has low airflow, it may be defective. In that case, shut it down, disconnect the power plug, and contact support for a replacement.
This answer is automatically generated