ELECRAFT K POD Owner's Manual page 18

Remove the three screws on the top lip of the front panel (see Figure 5)
Turn the K3/K3 over and remove the two screws on the bottom shown in Figure 6
S
Be sure all five screws have been removed, and then pry the front panel loose as shown in Figure 7. There
are four multi-pin connectors between the front panel assembly and the main chassis. Work carefully, loosening
one end a bit and then the other.
Figure 5. Removing the Top Front Panel Screws.
Figure 6. Removing the Bottom Front Panel Screws.
Figure 7. Disengaging the Front Panel Assembly.
17