Advertisement
Supreme Series
MODEL
ODD-300
INSTALLATION GUIDE
Plan the Installation
1. DO NOT use in a cooking area
2. Two ways to connect ductwork to a factory-shipped unit
Assembly Instructions
1. Sliding hanger bars have been provided, which
allow the housing to be positioned accurately
anywhere between the framing.
The bars span up to 24 inches and can be used
on all types of framing: I-joist, standard joist, and
truss construction.
Slide hanger bars onto housing and adjust as
needed to fit between framing.
2. Extend the hanger bars to the width of the
framing. Position the ventilator with the bottom
edge of the hanger bar tabs are flush with the
bottom edge of the framing, holding the
ventilator in place.
Secure hanger bars to framing using one screw
on each end of hanger bar.
Select a proper hole and secure the hanger bars
together using one screw.
info@ortechindustries.com
www.ortechindustries.com
13376 Comber Way
375 Admiral Blvd
Mississauga
Surrey BC V3W 5V9
,
ON L5T 2N1
Instruction Manual
1-888-543-6473
1-888-541-6474
Advertisement
