Waring WMO120 Manual page 15

5) To change the cooking factor: If you press X2, the screen will
display CF:XX. The default cooking factor is 80%, and CF:08 is
displayed. If you need to change the cooking factor, just press
one of the numbered buttons (1 for 10%, 2 for 20%, etc.).
6) After setting the time and power, press START, and the
cooking program will be saved. Once the program is saved,
PROGRAM is displayed.
7) If total cooking time exceeds the MAX time, use User
Option 7. Press START to save the program. The buzzer
will sound three times to indicate the oven is not in use.
Screen will display PROGRAM. The previous time set will
remain in place.
8) Close the door to return oven to Ready Mode. If STOP is
pressed during the programming process, the oven will enter
Door Open Mode, and any program not saved will be lost.
If there is program saved as memory procedure, press the
related number button to start the programmed operation.
If nothing has been saved, the buzzer will sound and the
oven will not operate.
Example:
Program: Power level PL7, cooking time 1 minute and
25 seconds.
Step 1: In waiting stage, press number button 1 for
Step 2: Press number 3. Program will be saved in 3.
Step 3: Press numbers 1, 2 and 5 to program the
Step 4: Press Med-Hi 70% button. 1:25 70 is displayed.
Step 5: Press START to save. When using the program next
NOTE:
1. If the electricity is cut off, the saved program will not be lost.
2. If the program needs to be reset, repeat the above steps.
3. If STOP is pressed instead of START at the last step, the
oven will go into Door Open Mode, and the program setting
will not be saved.
five seconds. PROGRAM is displayed.
cooking time.
time, just press 3, and the saved program will start.
15