Advertisement
APSUB-FD21
AmpPRO App (cont.)
AVAILABLE FREQUENCIES AND Q FACTORS
60HZ
Bass
80HZ
Frequency
100HZ
120HZ
0.50
Bass
1.00
Q Factor
1.50
2.00
Firmware Updates
The AmpPRO app will also allow you to update the interface with new firmware as it becomes available. Please visit
www.pac-audio.com or contact our tech support department to see if there is a firmware update for your interface.
Connect the interface to your PC and select "Firmware", then "Update Firmware". Now select "Select File". Finally, browse to the
place where you saved the file and select it. This will begin the updating process. Once finished, disconnect the interface from
the PC and resume normal operation.
Restoring Factory Settings
You can restore the interface to factory default settings by pressing and holding the programming button on the side of the module
for 10 seconds until the status LEDs start blinking red. Once the LEDs start blinking red, release the button.
This reset will restore the following settings to their factory defaults:
•
Minimum Volume Level
•
Enable / Disable Factory EQ
•
Factory EQ Frequency
•
Factory EQ Q Factor
Pacific Accessory Corporation
dB
F1
+15
+12
+9
+6
+3
0
-3
-6
-9
-12
20
63
F1: 60Hz Center Frequency | 0.50 Q Factor
© 2020 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
PAC-Audio.com
Advanced Subwoofer Amplifier Interface
F2
125
250
500
for Select Ford Vehicles
1k
2k
F2: 100Hz Center Frequency | 2.00 Q Factor
Rev: V1
Date: 091120
4k
8k
16
Page 4
Advertisement
