Adjustment Of The Running Belt - CAPITAL SPORTS Workspace GO Plus Manual

EN
36

ADJUSTMENT OF THE RUNNING BELT

The treadmill may expand after prolonged use and must be readjusted.
Tightening the treadmill belt
• When the belt is properly adjusted, the edge of the treadmill can be raised
about 5 cm from the running board. If the belt can be raised more than
this amount, the belt must be tightened.
• To tighten the belt, turn the two adjustment screws on the back of the
machine half a turn clockwise (see pictures). Lift the edge of the belt
to check that it is correctly adjusted. If there is still insufficient tension,
tighten the adjustment screws further in half-turn increments until the belt
is properly seated.
Centering the belt
If the Treadmill is moving to one side, you may need to center. Use the Allen
wrench to center.
• To adjust the treadmill to the right, turn the left adjustment screw half
a turn clockwise (left image) and the right adjustment screw half a turn
counterclockwise (right image).
• To adjust the running belt to the right, turn the left adjustment screw half
a turn anticlockwise and the right adjustment screw half a turn clockwise.
• Adjust until the belt is centered.