Use - Casselin C1BLANC Manual

ELECTRICAL HAZARD
Danger from electric current!
If incorrectly installed, the device can be dangerous and cause injury. Before any installation, check the data
of the electrical network. Connect the device only when there is compliance. The appliance must be unpacked
and checked completely before connection by a professional.

5.2 Use

WARNING
The set-up of the device installation and maintenance must be carried out by professionals only.
MANUAL
Position the hand dryer as shown in picture 1 in the diagram.
Loosen the housing from the back plate by unscrewing the 2 BTR screws using an Allen key.
Place the hand dryer approximately 1.30 meters from the floor, image 2.
Using the template supplied with the device, mark the positions of the fixing holes.
To hide the power supply, drill the cable entry hole.
Using a drill and an 8mm drill bit, drill the fixing holes in order to be able to place the plugs and fixing screws.
Insert the wall outlet so that it is flush with the mounting surface, then secure the back plate with the mounting
screws.
Release the cable clamp, pierce the insulating barrel plug, and slide it over the end of the cable. Disconnect
the electric current.
Bring the cable through the eyelet and connect the connection cable to the terminal on the connector, image
3 & 4:
 The brown or red conductor wire must be connected to the terminal marked A or the red wire to the
terminal block
The blue or black colored wire must be connected to the terminal marked B (neutral) or the blue wire
on the terminal block
The yellow / green colored wire must be connected to the terminal marked C (earth) or the yellow /
green wire on the terminal block
Before assembly, reconnect the sensor connectors and the earth cable by adjusting the earth cable to the
box and grouping the connectors together.
Replace the housing and secure the screws with the Allen key provided
Switch on the device
The device is designed for intensive use
wash your hands
Dry your hands and test operation by removing your hands and putting them back on several times.
NOTE
The device is fitted with a safety system in the event of overheating. If tripped, unplug the device and allow it
to cool. If this protection system operates regularly, it is imperative to contact your dealer.
After automatic shutdown, the device can only be put into operation by pressing the Reset button on the back
of the device, wait for the temperature to drop, press the Reset button.
EN