Related Manuals for Jefferson Olympus JEFGENPET30
Summary of Contents for Jefferson Olympus JEFGENPET30
- Page 1 OLYMPUS OLYMPUS PETROL GENERATOR Recoil Start With Electronic Ignition & AVR • 7HP OHV Petrol Engine (Stage V) JEFGENPET30 User Manual v.2.1...
-
Page 3: Table Of Contents
ABOUT THIS DOCUMENT This manual has been compiled by Jefferson Tools and is an integrated part of the product with which it's enclosed and should be kept with it for future reference. Please read all of the information supplied in this User Manual before operating this product. -
Page 4: Specifications
USER MANUAL v2.1 JEFGENPET30 3.8kVA Petrol Generator - Recoil Start SPECIFICATIONS Max Output: 3.8kVA / 3.0kW Rated Output: 3.3kVA / 2.6kW Power Factor: Ac Output: 1 X 230V 16A / 1 X 110V 16A Dc Output: 12V / 8.3A Engine Model: Macgen 7HP Stage V / 3600rpm Engine Type: OHV Petrol •... -
Page 5: Safety Guidelines
USER MANUAL v2.1 JEFGENPET30 3.8kVA Petrol Generator - Recoil Start SAFETY GUIDELINES Please read and ensure that you understand all of the operating instructions, safety precautions and warnings in this Instruction Manual before operating or maintaining this equipment. An accident can often be avoided by recognizing a potentially hazardous situation before it occurs, and by observing the appropriate safety procedures. - Page 6 USER MANUAL v2.1 JEFGENPET30 3.8kVA Petrol Generator - Recoil Start EQUIPMENT SAFETY (continued) • Do not tamper with parts, which may increase or decrease the governed speed. • When using extension cords, please make sure they are grounded with sufficient wire gauge for the application. Heavy-duty outdoor rated cords will handle household appliance loads.
-
Page 7: Checking The Generator Prior To Use
USER MANUAL v2.1 JEFGENPET30 3.8kVA Petrol Generator - Recoil Start CHECKING THE GENERATOR PRIOR TO USE • Check the fuel level and top up with unleaded petrol if necessary. Do not overfill the fuel tank (there should be no fuel in the filler neck). •... -
Page 8: Stopping The Generator
USER MANUAL v2.1 JEFGENPET30 3.8kVA Petrol Generator - Recoil Start STOPPING THE GENERATOR 1. Before stopping the generator, allow it to run for approximately 3 minutes with no consumers so that it can "cool down". 2. Turn off the circuit breaker. 3. -
Page 9: Maintenance
The chart below indicates the maintenance checks you should make on your generator parts and the frequency that these checks should generally be carried out. Note: You can contact your nearest Jefferson dealer for help and advice and a full list of replacement parts. -
Page 10: Troubleshooting
Carbon brush is faulty or worn Replace the carbon brush AVR is depreciated Replace the AVR Parts & Servicing For Jefferson approved replacement parts contact your nearest dealer or contact Jefferson tools Telephone: +44 (0)1244 646 048 Fax: +44 (0)1244 241 191 Email: warranty@jeffersontools.com... -
Page 11: Circuit / Wiring Diagram
USER MANUAL v2.1 JEFGENPET30 3.8kVA Petrol Generator - Recoil Start CIRCUIT / WIRING DIAGRAM www.jeffersontools.com... -
Page 12: Parts List - Generator
USER MANUAL v2.1 JEFGENPET30 3.8kVA Petrol Generator - Recoil Start PARTS DIAGRAM - GENERATOR www.jeffersontools.com... -
Page 13: Parts Diagram - Generator
USER MANUAL v2.1 JEFGENPET30 3.8kVA Petrol Generator - Recoil Start PARTS LIST - GENERATOR Description Quantity Description Quantity Petrol Engine Spring Washer Ø8 Alternator Front Cover Flange Bolt M8x25 (With Flat Washer) Motor Flange Bolt M8x25 (With Flat Washer And Spring Washer) Alternator End Cover Bolt (With Flat Washer And Spring Washer) Connection Pole... -
Page 14: Parts List - Engine
USER MANUAL v2.1 JEFGENPET30 3.8kVA Petrol Generator - Recoil Start PARTS DIAGRAM - ENGINE www.jeffersontools.com... -
Page 15: Parts Diagram - Engine
USER MANUAL v2.1 JEFGENPET30 3.8kVA Petrol Generator - Recoil Start PARTS LIST - ENGINE Description Quantity Description Quantity Bolt M8x33.5 Outlet Valve Oil Sealing B2541 Inlet Valve Crankcase Cover Cylinder Head Gaskets Oil Dipstick Pin10x16 Crankcase Gaskets Flywheel Pin 8X14 Flywheel Fan Bearing 6205 Ignition Coil... -
Page 16: Limited Warranty Statement
Jefferson will assume both the parts and labour expense of correcting defects during the stated warranty periods below. All warranty periods start from the date of purchase from an authorised Jefferson dealer. If proof of purchase is unavailable from the end user, then the date of purchase will be deemed to be 3 months after the initial sale to the distributor. - Page 17 • A Warranty Returns form will be sent to you for completion and return by post or fax, together with details of your nearest authorised Jefferson repair centre. On receipt of this form Jefferson will arrange to collect the equipment from you at the earliest convenience.
-
Page 18: Ec Declaration Of Conformity
JEFGENPET30 3.8kVA Petrol Generator - Recoil Start EC DECLARATION OF CONORMITY We, Jefferson Professional Tools & Equipment, as the authorised European Community representative of the manufacturer, declare that the following equipment conforms to the requirements of the following: Directive / Standard / Regulation... - Page 20 Before attempting to use this product please read all the safety precautions and operating instructions outlined in this manual to reduce the risk of fire, electric shock or personal injury. Jefferson Tools, Herons Way, Chester Business Park, Chester, United Kingdom, CH4 9QR Tel.
Need help?
Do you have a question about the Olympus JEFGENPET30 and is the answer not in the manual?
Questions and answers